What kind of transmission fluid does a 2006 Ford Explorer take?
Lubegard Synthetic Synthetic Transmission Fluid Dexron VI 1 Quart.
How much fluid does a 5R55S transmission hold?
5R55S/W transmissions behind 3.0L & 3.9L engines will have a dry fill capacity of 11.2 quarts.
How many quarts of transmission fluid do I need for a 2006 Ford Explorer?
The capacity for transmission fluid on the 2006 Ford Explorer is 11 quarts.To change the transmission fluid You will want to first make sure the car is level on the ground and then pop the hood open. Now locate the transmission fluid container, it should be on or near the transmission itself, and find the dipstick.
Where do you check the transmission fluid on a 2006 Ford Explorer?
The only way to check the transmission fluid is by using the valve that is located on the side of the oil pan for the transmission. You will need to drain a small amount of fluid and then close the valve to make sure that it is free from signs of debris.
How many quarts of oil does a 2006 Ford Explorer v8 take?
Engine Oil
| Viscosity: | 5W-30 (All TEMPS) |
|---|---|
| Capacity: | 5 quarts (with filter)When refilling, remove dipstick to provide adequate venting and allow oil to flow into crankcase. After refill, check oil level. Top off to proper level as needed. |
| Torque: | 18 ft/lbs (Oil Drain Plug) |
Where is the transmission fluid dipstick on a 2006 Ford Explorer?
The 2006 Ford Explorer does not have a transmission dipstick. Ford has figured that the transmission is sealed well enough that You should not need to check the fluid Yourself. Usually a mechanic at a Ford dealership will inspect the fluid when they do an oil change.
When did Ford start using 5R55 transmission fluid?
The 5R55 series was used in a wide range of FoMoCo (Ford Motor Company) vehicles from about 1999-2010. While reviewing a common procedure used to fill the transmission fluid in these transmissions, I thought I might have a better solution than buying a ridiculous $120 tool just for this procedure.
What kind of fluid does Ford Explorer use?
Ford Mercon V is the fluid required for this transmission. In this video I show you how to fill and adjust the 5R55S after a repair that has required a fluid drain or loss. If you follow this procedure you will have no issues with the proper fill level of the 5R55S.
How to install a 5R55 transmission in a car?
There is a simple way to fill the transmission before it is installed in your vehicle. Once the transmission is on the jack and ready for installation, fill it using the following procedure. Use only the supplied synthetic or OEM approved fluid. Install a funnel into the center speed sensor hole on top of the transmission. Pour in 8 quarts of ATF.
Is there a dipstick on the Ford 5R55N?
The Ford 5R55N/S/W transmission has no dipstick, no fill/check plug, and really no easy way to check the transmission fluid.