What kind of transfer case does Jeep 1941-79 have?
On all Jeep vehicles 1941-79, equipped with the Dana Spicer 6 spline transfer case, you will have the largest selection available for transfer case adapters. These adapters are for replacement of Jeep transmissions that have a 6 spline input gear to the transfer case.
Can a Jeep transfer case lose its lubricant?
Another thing to be aware of is the tendency of the slip-type yoke to pull and separate from the transfer case during extra articulation of the rear axle. Unless you own a TJ model 231, you will rapidly lose the ATF lubricant from the case if this occurs. The 231 is possibly the simplest of all the Jeep transfer cases to rebuild.
What’s the difference between Dana and Jeep transfer cases?
Another difference is that the Model 20 transfer cases have the power to the rear axle directly in line with the transmission, while the Dana 18 has the power offset to the passenger side. On all Jeep vehicles 1941-79, equipped with the Dana Spicer 6 spline transfer case, you will have the largest selection available for transfer case adapters.
What was the reduction ratio on a Jeep transfer case?
These transfer cases have a four position shifter that provides two gear ratios in 4WD, one ratio in 2WD, and a neutral position. Four wheel drive low provides a reduction ratio of 2.03:1 on the Dana 20, and a 2.46:1 on the Dana 18. The controls varied from a dual lever design to a single lever on the later models.
On all Jeep vehicles 1941-79, equipped with the Dana Spicer 6 spline transfer case, you will have the largest selection available for transfer case adapters. These adapters are for replacement of Jeep transmissions that have a 6 spline input gear to the transfer case.
What does transfer case fluid do in Jeep?
Usually when the message pops up when shifting to low it is a result of a faulty shift motor, but it could be a whole bunch of things. Click to expand… And what does your owner’s manual indicate the t-case uses for lube? And if you don’t have an OM, have you looked at Jeep.com for one? Click to expand…
Another difference is that the Model 20 transfer cases have the power to the rear axle directly in line with the transmission, while the Dana 18 has the power offset to the passenger side. On all Jeep vehicles 1941-79, equipped with the Dana Spicer 6 spline transfer case, you will have the largest selection available for transfer case adapters.
These transfer cases have a four position shifter that provides two gear ratios in 4WD, one ratio in 2WD, and a neutral position. Four wheel drive low provides a reduction ratio of 2.03:1 on the Dana 20, and a 2.46:1 on the Dana 18. The controls varied from a dual lever design to a single lever on the later models.
When did the Dana 20 transfer case come out?
The Dana 20 is found in 1962-1979 Jeep vehicles. It is also found in IH and Ford vehicles as well as a limited run of GM trucks in the early-mid 1970’s. The Dana 20’s design was outstanding and remains one of the strongest and most refined of all the popular transfer cases.
What was the wheelbase of the Jeep J-2000?
In late 1965, the J-200 and J-300 Gladiators became known as the J-2000 and J-3000 respectively. The J-2000 featured a 120-inch wheelbase, and the J-3000 had a 126-inch wheelbase. They were available in two or four-wheel drive configurations.
The Dana 20 is found in 1962-1979 Jeep vehicles. It is also found in IH and Ford vehicles as well as a limited run of GM trucks in the early-mid 1970’s. The Dana 20’s design was outstanding and remains one of the strongest and most refined of all the popular transfer cases.