What kind of problem does a Jeep Compass have?
Tl- the contact owns a 2009 Jeep Compass. The contact stated that while driving at approximately 70 mph, the vehicle stalled without warning while in traffic. The vehicle was able to coast to the side of the road. The contact attempted to restart the engine but it failed to start. The contact also stated that the failure recurred three times.
Why is my turn signal not working on my Jeep Compass?
Bad ground is sounding to be a key candidate here. Metering is the only way. There is a cluster of ground wires on a lug as I recall at front drivers cross member which is left of the headlight. If the vehicle was never rust proofed or sprayed a good deal of corrosion has likely set in.
What was the failure mileage on a 2009 Jeep Compass?
The approximate failure mileage was 7,500. Ah. Tl- the contact owns a 2009 Jeep Compass. The contact stated that while driving at approximately 70 mph, the vehicle stalled without warning while in traffic. The vehicle was able to coast to the side of the road. The contact attempted to restart the engine but it failed to start.
Where are the ground wires on my Jeep Compass?
Metering is the only way. There is a cluster of ground wires on a lug as I recall at front drivers cross member which is left of the headlight. If the vehicle was never rust proofed or sprayed a good deal of corrosion has likely set in. I would not be looking at fuse or such since generally there is power.
What does it mean when your Jeep Compass won’t start?
The first and most common is when it won’t turn over. This just means that the engine doesn’t move when you turn the key. The second way that your Compass won’t start is when the engine turns when you engage the starter, but it won’t fire and run on its own.
Why is my Jeep PCM not working properly?
If the problem was only with the scanner connection, the jeep would at least run normally. Now these 2 problems combined would lead to think that there is some electrical connection problem with the PCM. I would disconnect the battery and then disconnect and clean the PCM connectors with electrical contact cleaner.
How to reset your Jeep engine control module?
3- Once the time has passed you should now turn the headlights “on” and “off” twice to drain the Engine Control Module from any remaining power. 4- Now plug back in the negative terminal and your Jeep ECM should now be reset. To finish off this post , here are a couple of things you should keep in mind.
Why does my Jeep not start in Park?
So went down to get a burrito, everything fine. Came back out to start it, nothing. The jeeps shifter is in park but will roll forward and back so it must not be in park. Everything works as far as electrical and I’m not throwing codes.