What kind of oil do I need for a Polaris Ranger 500?
The recommended oil is Polaris PS-4 Full Synthetic, which is part number 2876245 for 1 gallon and part number 2876244 for 1 quart. Polaris Oil Change Kits come with the correct amount of oil for your vehicle. The oil change kit for a RANGER 500 is part number 2202166. Note: Do not overfill.
Where do you change the oil in a Polaris Ranger?
The crankcase drain plug is located on the bottom of the crankcase. Access the drain plug from the bottom of the vehicle. To change the oil and filter, do the following: 1. Position the vehicle on a level surface in a well-ventilated area. 2. Place the transmission in PARK. 3. Start the engine. Allow it to warm up at idle for 2 to 3 minutes. 4.
How do you change oil on a Polaris Sportsman 500?
Warm up oil, drain from oil tank, replace bolt. Start engine for ONLY 10 seconds, shut down, remove oil tank drain bolt again allowing to drain and replace oil filter then drain bolt. Got this idea from OPT (an old polaris tech on ATVConnection) that got it from a Polo engineer.
What is the oil filter number on a Ranger 500?
The oil filter for a RANGER 500 is part number 2540086. 16. Install a new sealing washer on the drain plug. The sealing surfaces on drain plug and crankcase should be clean and free of burrs, nicks or scratches.
The recommended oil is Polaris PS-4 Full Synthetic, which is part number 2876245 for 1 gallon and part number 2876244 for 1 quart. Polaris Oil Change Kits come with the correct amount of oil for your vehicle. The oil change kit for a RANGER 500 is part number 2202166. Note: Do not overfill.
The crankcase drain plug is located on the bottom of the crankcase. Access the drain plug from the bottom of the vehicle. To change the oil and filter, do the following: 1. Position the vehicle on a level surface in a well-ventilated area. 2. Place the transmission in PARK. 3. Start the engine. Allow it to warm up at idle for 2 to 3 minutes. 4.
The oil filter for a RANGER 500 is part number 2540086. 16. Install a new sealing washer on the drain plug. The sealing surfaces on drain plug and crankcase should be clean and free of burrs, nicks or scratches.
What makes a Polaris Ranger a good prospector?
DURABILITY AND RELIABILITY: Triple sealed main bearings along with an oil bath bearing housing offer superior load ratings and resist contamination for longer life expectancy in the field.