What kind of equipment does a Volkswagen Jetta have?
These Three OE Categories Are:: 1 – Standard Equipment 2 – Engine Specific 3 – System Specific and Optional Equipment (Common Systems) Standard Equipment This category includes equipment such as Instrument Cluster and Gauges, Headlights/Tail Lights/Turn Signals, Rear Window Defroster, Wipers and Washers, etc..
Where is the engine code on a 1.9 liter VW?
1.9 Liter TDI Models: You’ll find the engine code on a sticker attached to the timing belt cover. However, over time the numbers become very hard to read so we recommend recording your engine code and saving it somewhere safe for future reference.
Where is track 175 on VW Jetta wiring diagram?
This wire/circuit is running on track 8 of the diagram and terminates at the box labeled 175. To continue tracing this wire/circuit, you must now go to Track 175, which is located within the diagram named Track 169-182. But before going to the diagram named Track 169-182, again make note of the current track that you are leaving, which is Track 8.
Where is the ignition switch on a VW Jetta?
– With ignition switched off, connect VAS 5051/5052 with adapter cable to Data Link connection (DLC) located under instrument panel, left. – Switch on tester -arrow- Switch on ignition – Switch off all electrical consumers.
What are the parts numbers on a VW Jetta?
Engine Control Module Adapting to Throttle Valve Control Module fPage 62 – Antenna cables – Touareg 2004 > 2006 Tip: Part numbers listed in this bulletin are for reference only Always check with your Parts Dept. for the latest parts information. fPage 326 fWHAT ARE TRACKS?
How to check the wiring of a VW Jetta?
Using the test box V.A.G 1598/18 the wiring can be checked according to the wiring diagram. NOTE: – Before connecting test leads the correct measuring range on the tester must be adjusted. Otherwise the electronic components can be destroyed! – Use the multimeter V.A.G 1526 with auxiliary cables from V.A.G 1594 for testing.
How to turn on ignition on Volkswagen Jetta?
Switch ignition on and select engine control module with “Address word” 01. (Connecting scan tool and selecting engine control module).
Where to insert switch 2 in VW Jetta?
– Insert switch -2- (or switch -3-) into vent and engage. fPage 174 f- Place sufficient lint-free cloths under the ABS control module and hydraulic unit – fRemove brake lines -3- on the side of hydraulic unit CAUTION: DO NOT BEND BRAKE LINES IN THE AREA OF THE HYDRAULIC UNIT.