What kind of coolant does a 2005 Honda Civic use?
The 2005 Honda Civic uses ZerexBlue 50/50 antifreeze engine coolant. It has a capacity of about 1.3 gallons. Coolant is used to transfer heat which can assist in preventing engine damage caused by freezing or boiling.
How much coolant does a 2005 Honda Civic take?
The 2005 Honda Civic has a coolant capacity of 4.2 quarts for the initial fill with MTXL or 4.1 quarts for initial fill with ATXL for the 1.7 L 4Cylinder engine and 4.1 quarts for initial fill for the 2.0 L 4Cylinder engine.
How much antifreeze does a 2005 Honda Civic take?
Where is the coolant reservoir on a Honda Civic?
The video above shows you where the coolant reservoir in your Civic is located and how to add coolant. Be sure to check your owners manual to determine the correct type of fluid to add – for Hondas, it will typically be in a section titled Fluid Capacities in the back of your manual.
Where is the drain hose on an evaporator?
If this happens to you, the evaporator drain tube needs to be cleaned as well as the evaporator itself. The AC drain hose or evaporator drain hose, as it’s often referred to, is located on the engine compartment side of the firewall.
How to do a coolant flush on a Honda Civic?
Coolant Flush How-to: Honda Civic (2001-2005) Mix the coolant with distilled water so that you have a combination of 50% coolant and 50% water. Some coolants will come premixed…that is, you don’t need to add any water. These coolants will typically say 50/50 or pre-mixed on the front of the coolant bottle.
Where is the drain bolt on a Honda Civic?
Figure 2. Engine block drain bolt location. Locate the thermostat housing. You can do so by following the upper radiator hose to the engine block. Position your drain pan as best you can under the hose, so that it can catch any fluid when you disconnect it.
Where is the thermostat on a Honda Civic?
Locate the thermostat housing. You can do so by following the upper radiator hose to the engine block. Position your drain pan as best you can under the hose, so that it can catch any fluid when you disconnect it. Remove the radiator hose from the thermostat housing.
If this happens to you, the evaporator drain tube needs to be cleaned as well as the evaporator itself. The AC drain hose or evaporator drain hose, as it’s often referred to, is located on the engine compartment side of the firewall.
The video above shows you where the coolant reservoir in your Civic is located and how to add coolant. Be sure to check your owners manual to determine the correct type of fluid to add – for Hondas, it will typically be in a section titled Fluid Capacities in the back of your manual.