What kind of battery does a Harley Davidson key fob use?
1. Insert a five cent coin or similar size blade into the thumbnail slot on the side of the FOB to separate the two halves. 2: Remove the old battery and discard. 3: Install a new battery (Size 2032) with the positive (+) side facing down.
Is it possible to take used key fob and reprogram it?
Take the key out of the door and with the door shut, try to unlock the doors with the remote. If the doors will lock then put the key in the ignition switch and try to start the engine. If the engine starts up after these steps, then the key fob is successfully reprogrammed to your vehicle.
How to program a new key fob for a Harley Davidson?
How to Program a New Key Fob for a Harley. Turn the key in the ignition to “On,” “Off,” “On,” “Off,” then back to the “On” position. Press the left turn signal switch for a total of two times. Wait for the lights to blink one to three times in response, depending on the configuration of your motorcycle’s system.
What to do when your car key fob is not working?
Once the above steps are performed, turn the ignition back to the ‘Off’ position to terminate the programming procedure. Take your key fobs with you and leave the vehicle and close all doors. Test to both unlocks with all your key fobs that got programmed to verify the function.
How long does it take to program key fobs?
If there are additional remotes, press the ‘Lock’ button within 10 seconds after you enter the programming mode to program those remotes as well successfully. Once the above steps are performed, turn the ignition back to the ‘Off’ position to terminate the programming procedure. Take your key fobs with you and leave the vehicle and close all doors.
Take the key out of the door and with the door shut, try to unlock the doors with the remote. If the doors will lock then put the key in the ignition switch and try to start the engine. If the engine starts up after these steps, then the key fob is successfully reprogrammed to your vehicle.
How long does it take to program a Harley Davidson FOB?
Press and release the left-hand turn switch once. Press and hold the key fob button for 10 to 25 seconds or until the programming process is complete. Turn ignition key off. Figure 1. You can program your key fob in under 10 minutes in most cases. Before getting started, make sure that your key fob has fresh batteries in it.
What is the FOB on a Harley Davidson?
This transmitter is referred to as a key FOB. If your Harley key FOB is ever lost, damaged, or stolen, you can easily assign a new key FOB to your Harley. It is also possible to have two FOBs assigned at once.
How to program a Harley Davidson touring key fob?
Step 1 – Complete the programming procedure. 1 Step 1 – Complete the programming procedure. Grab your key fob and turn the ignition key on and off for a total of five passes. 2 Step 2 – Visit your local dealer. 3 Step 3 – Start the bike without the key fob.