What is the tightness torque specification for the drain plug?
The typical torque specification for oil drain plugs on an aluminum oil pan is 20 to 25 foot-pounds.
What should transmission bolts be torqued to?
The automatic transmission flexplate must be torqued to 60 ft.
Should I torque oil drain plug?
you don’t have to be exact with torque 30-36 ft lbs would be fine with your drain plug. to keep things in perspective, if this is your first oil change on this car, then there would have been at least one oil changer that ran your drain plug down with an impact, and probably no one used a torque wrench.
What happens if you over torque transmission pan bolts?
Over tightening the bolts can easily damage the pan of a transmission. The flange of the transmission pan should be flat and have no bulges. Over tightening the pan bolts causes the flange to distort. Inspect the pan and make sure the flange is flat.
How much fluid goes in a 700R4 transmission?
| Transmission Fluid Capacity | |
|---|---|
| Transmission (w/ Stock Pan) | # of Quarts |
| GM 700R4/4L60E | 6 |
| GM 2004R | 6 |
| GM 4L80E | 7.7 |
How do you check the transmission fluid on a 2001 Toyota Corolla?
How to Check Automatic Transmission Fluids
- Pull out the dipstick. Put the car in Neutral or Park with the braking on, and keep the car running.
- Check the fluid. The transmission fluid on the dipstick should be bright red and almost clear.
- Wipe the dipstick with a clean rag, reinsert it, and pull it out again.
What are torque values for 2009 Toyota Corolla?
Hi, I need the torque values for the 2009 Corolla transmission pan bolts, drain plug and filter bolts (U341E). I plan to change the transmission filter and pan gasket.
What is the torque spec for oil drain plug?
The oil drain plug may be a basic drain plug, but the torque amount will be different. The typical torque specification for oil drain plugs on an aluminum oil pan is 20 to 25 foot-pounds.
What are the torque specs for the transmission pan?
Planning to drop the transmission pan this weekend, but manual says torque specs is only 43inlbs. It seems low. I would expect between 80-100 inlbs. What is the proper torque specs for the rubber gasket? Thanks, 2000 Toyota Camry 2.2L. Planning to drop the transmission pan this weekend, but manual says torque specs is only 43inlbs.
How big of a torque wrench do I need to drain transmission fluid?
If you have a torque wrench, get it to 36 ft*lbs. If you don’t get it snug but don’t kill it. You want to be able to get it out again, and the last thing you want to do is strip the pan.