What is the fuel mix for a mini moto?
Your mini moto should be ‘run in’ for the first 3-4 tanks of fuel. During this period we recommend that you use a fuel mixture of 25:1. This means a mixture that is made up of 25 parts petrol to 1 part of two stroke oil.
What kind of spark tester do I need to start my engine?
You can do this test without a spark tester, but it’s better to use one because a weak spark as well as a missing spark can prevent your engine from starting. If possible, use an adjustable tester so that you can test for 40KV, 30KV, and 10KV spark.
How to start an ATV that wont start?
1 Remove the spark plug from the cylinder-head and connect it to the spark-plug wire or ignition coil. 2 Grab the plug wire and hold the plug about 1/8th of an inch away from the cylinder head. 3 Activate the starter. 4 As the motor turns, you should see repetitive bright blue spark arching from the spark plug to the cylinder head.
Why is my ATV not getting a spark?
You will find the proper steps for troubleshooting an ATV that is not getting a spark further down this post. If the spark plug is still dry after cranking the engine for a few seconds, you know that fuel, for some reason, is not getting to the cylinder.
Where is the IAT sensor on my Arctic Cat Prowler?
The IAT sensor is usually located in the side of the air box or intake tube before the throttle body. Ok I got the new map sensor pit on and reset the code. I don’t have any codes that come up at this time.
1 Remove the spark plug from the cylinder-head and connect it to the spark-plug wire or ignition coil. 2 Grab the plug wire and hold the plug about 1/8th of an inch away from the cylinder head. 3 Activate the starter. 4 As the motor turns, you should see repetitive bright blue spark arching from the spark plug to the cylinder head.
You will find the proper steps for troubleshooting an ATV that is not getting a spark further down this post. If the spark plug is still dry after cranking the engine for a few seconds, you know that fuel, for some reason, is not getting to the cylinder.
The IAT sensor is usually located in the side of the air box or intake tube before the throttle body. Ok I got the new map sensor pit on and reset the code. I don’t have any codes that come up at this time.