What is the fault code for the GSXR ECU?
TP sensor, wiring/coupler connection. The sensor voltage should be the following. (0.15 V < or = sensor voltage < 4.85 V) Without the above range, c15 is indicated. ECT sensor, wiring/coupler connection. The sensor voltage should be the following. (0.15 V < or = sensor voltage < 4.85 V) Without the above range, c21 is indicated.
Is the ECU sensor on a Suzuki GSXR street legal?
The stock narrow-band sensors on later GSXR models are not suitable for tuning anyway, but you will have to find a good shop to weld the O2 bung (that the sensor screws into) to your K5 header. Yes it’s a little expensive, but this is probably the best system around. Just bear in mind that none of this is really street legal…
What is the CKP code on a GSXR?
TO sensor, wiring/coupler connection. CKP sensor (pick-up coil) signal is produced but signal from ignition coil is not produced continuous two times. In this case, the code c24 or C25 or C26 or c27 is indicated.
Why is the transponder ECU under the dash?
The reason for separating the Transponder ECU with the EEPROM storing the keys is that in the invent of lost keys, it would be cheaper for a dealership to replace the Transponder ECU than the Engine Control Unit. However its location under the dash means you will have to remove the entire dash pad.
What should the sensor voltage be on a GSXR?
The sensor voltage should be the following. (0.15 V < or = sensor voltage < 4.85 V) Without the above range, c15 is indicated. ECT sensor, wiring/coupler connection.
What kind of wiring harness does a Suzuki GSXR750 use?
Suzuki GSXR600 GSXR 600 Electrical Wiring Harness Diagram Schematic 2001 – 2003 HERE Suzuki GSXR750 GSXR 750 Electrical Wiring Harness Diagram Schematic 1991 1992 HERE Suzuki GSXR750 GSXR 750 Electrical Wiring Harness Diagram Schematic 1993 1994 1995 HERE Suzuki GSXR750 GSXR 750 Electrical Wiring Harness Diagram Schematic 1996 1997 HERE
TP sensor, wiring/coupler connection. The sensor voltage should be the following. (0.15 V < or = sensor voltage < 4.85 V) Without the above range, c15 is indicated. ECT sensor, wiring/coupler connection. The sensor voltage should be the following. (0.15 V < or = sensor voltage < 4.85 V) Without the above range, c21 is indicated.
TO sensor, wiring/coupler connection. CKP sensor (pick-up coil) signal is produced but signal from ignition coil is not produced continuous two times. In this case, the code c24 or C25 or C26 or c27 is indicated.
The sensor voltage should be the following. (0.15 V < or = sensor voltage < 4.85 V) Without the above range, c15 is indicated. ECT sensor, wiring/coupler connection.