What is the diagnostic code for DTC b0958?
DTC B0961 01 Parking Aid Rear Sensor 1 Right Corner Circuit Short to Battery DTC B0961 06 Parking Aid Rear Sensor 1 Right Corner Circuit Short to Ground or Open DTC B0961 08 Parking Aid Rear Sensor 1 Right Corner Circuit Signal Invalid DTC B0961 21 Parking Aid Rear Sensor 1 Right Corner Circuit Incorrect Period Diagnostic Fault Information
When to reset or recalibrate steering angle sensor?
The Steering Angle Sensor need to be reset or recalibrated after an alignment is per formed or parts in the steering system are replace.For example:steering wheel,airbag spring contact,steering column,etc… How to reset or recalibrate Steering Angle Sensor (SAS)?
What to do if ABS wheel speed sensor goes out?
If the ABS wheel speed sensor was faulty, once the new hub/sensor is installed, and you drive the vehicle, the warning lights should go out. To determine what is going on, you can manually erase the trouble codes using an appropriate scan tool and if the warning lights stay off, then the problem is resolved.
When to replace a Rear Parking Assist Sensor?
Silicone insulator surrounding sensor maybe missing, cut, or twisted. Replace sensor insulator ring if damaged. One or more of the sensors may be scratched, the paint maybe chipped or excessive paint on sensor that is greater than 6 mils thickness. Replace sensor. Refer to Rear Parking Assist Alarm Sensor Replacement procedure.
What happens to the crank sensor on a GMC?
The crankshaft sensor on GMC vehicles is synced to the powertrain control module, or PCM. When the crank sensor is replaced, it must be resynced to the PCM. Without resyncing, the PCM cannot properly determine the position of the crankshaft.
Silicone insulator surrounding sensor maybe missing, cut, or twisted. Replace sensor insulator ring if damaged. One or more of the sensors may be scratched, the paint maybe chipped or excessive paint on sensor that is greater than 6 mils thickness. Replace sensor. Refer to Rear Parking Assist Alarm Sensor Replacement procedure.
What to do if there are no park sensors?
Then they hook up the battery again, and voila… no more park sensors. Now if you just followed this procedure, then after having the pickup think there are no park sensors like above, then take off the battery cable, then plug the park assist sensor fuse back in and then hook the battery back up again.