What is the code P1494?
OBD II fault code P1494 is a manufacturer specific code that is defined by car makers Chrysler, Dodge, Jeep, and Plymouth as “EVAP Leak Detection Pump Pressure Switch Condition”, or sometimes as “Leak Detection Pump SW or Mechanical Fault”, or less often as “Mechanical Incorrect input state detected for the Leak …
What does the p0304 code on my engine mean?
Tech notes The P0304 code means that the cylinder 4 is misfiring or is randomly misfiring. Start by checking for intake leaks and if no leaks are found the next step is to replace the spark plugs on cylinder 4. If the problem persists more tests needs to be done to diagnose problem, see “Possible Causes” Engine Cylinder 4 is Misfiring.
What do you need to know about code p1494?
Apart from a stored trouble code and an illuminated warning light, the only other noteworthy symptoms of code P1494 may be the presence of a strong fuel odor as vapors are released from leak sites, and that the vehicle may not pass an emissions test.
When do you need to fix a p0304 misfire?
When P0304 occurs, it should be fixed immediately as long term driving with engine misfires could cause consequential damage to your engine. Many times, P0304 occurs when there are worn out spark plugs, spark plug wires, or a faulty ignition coil.
What causes a p1494 leak in a PCM?
Typical causes of P1494 could include the following-. Defective Leak Detection Pump. Damaged, burnt, shorted, disconnected, or corroded wiring in the LDP Switch Control Circuit, or in one or more control circuits of sensors that supply input information to the LDP/PCM.
What does the p1494 code on a jeep mean?
P1494 JEEP Meaning The Evaporative emissions system is designed to prevent the escape of fuel vapors from the fuel system. Leaks in the system ca allow vapors to escape into the atmosphere.
What does diagnostic trouble code p0304 mean?
The diagnostic trouble code P0304 signifies that a misfire in the engine was detected by the vehicle’s computer system. To be more specific, this misfire happens in the fourth cylinder. Are you trying to get rid of code P0304?
When does code p1494 set in Powertrain Control Module?
Note however that the above definitions all have the same basic meaning, which is that code P1494 sets when the PCM (Powertrain Control Module) has detected a malfunction in the LDP ( [EVAP] Leak Detection Pump) itself, as opposed to when a leak in the EVAP system is detected.
What are the symptoms of stored trouble code p1494?
Apart from a stored trouble code and an illuminated warning light, the only other noteworthy symptoms of code P1494 may be the presence of a strong fuel odor as vapors are released from leak sites, and that the vehicle may not pass an emissions test. Note that this code very rarely produces driveability issues.