What is the administrative distance for RIP?
120
By default, OSPF has a default administrative distance of 110 and RIP has a default administrative distance of 120.
What is the lowest administrative distance?
A directly connected will always have the lowest, at 0. A static route will always have an AD of 1, EIGRP is 90, and OSPF is 110.
What is the administrative distance of RIP quizlet?
RIP has an administrative distance of 120.
Which one has a highest administrative distance?
Administrative Distance (AD) is a numeric value which can range from 0 to 255. A smaller Administrative Distance (AD) is more trusted by a router, therefore the best Administrative Distance (AD) being 0 and the worst, 255.
What is the administrative distance of default routes?
The range for administrative distance is 1–255. The default value is 115 for IS-IS routes….Setting the Administrative Distance for a Route.
| Route Source | Default Distance |
|---|---|
| Internal access route | 2 |
| Access route | 3 |
| External BGP | 20 |
| OSPF | 110 |
What is the default range of administrative distance?
The range for administrative distance is 0–255. The default value is 120 for RIP routes and 110 for OSPF routes.
Why is BGP needed?
BGP allows different autonomous systems on the Internet to share routing information. The gateways of autonomous systems are called Autonomous System Boundary Routers (ASBR). BGP allows each peer to collect routing information from its neighboring peer and later advertise that information, in its entirety, further.
What is the administrative distance for a directly connected route in Cisco networking quizlet?
The administrative distance of this route is 1. Refer to the exhibit. Router1 and Router2 are running EIGRP. All interfaces are operational and packets can be forwarded between all networks.
What is an administrative distance of 0 mean?
The administrative distance (AD) is a number used to rate the trustworthiness of the routing information received from a neighbor router. The AD of 0 indicates the most trusted route (the directly connected network). The AD of 255 means that the route will not be trusted.
How do I change administrative distance for RIP?
To set an administrative distance:
- For RIP and OSPF, issue the distance command in Router Configuration mode. host1(config-router)#distance 100. The range for administrative distance is 0–255.
- For IS-IS, issue the distance ip command in Router Configuration mode. host1(config-router)#distance 80 ip.
What should the administrative distance be for Rip routes?
In order to enable the router to prefer RIP routes to IGRP, configure the distance command on R1 like this: Now look at the routing table. The routing table shows that the router prefers the RIP routes. The router learns RIP routes with an administrative distance of 90, although the default is 120.
When to increase the administrative distance of IGRP?
For example, if you want the router to select RIP-learned routes (default value 120) rather than IGRP-learned routes (default value 100) to the same destination, you must increase the administrative distance for IGRP to 120+, or decrease the administrative distance of RIP to a value less than 100.
What is the administrative distance for R2 router?
The routing table shows that the router prefers the RIP routes. The router learns RIP routes with an administrative distance of 90, although the default is 120. Note that the new administrative distance value is relevant only to the routing process of a single router (in this case R1). R2 still has IGRP routes in the routing table.
What’s the difference between OSPF and Rip routes?
For example, Cisco routers, routes issued by OSPF have a lower default administrative distance than routes issued by the Routing Information Protocol. By default, OSPF has a default administrative distance of 110 and RIP has a default administrative distance of 120. Administrative distance values can, however, usually be adjusted manually by