What is passlock system?
The PassLock system was designed to prevent vehicle theft by disabling fuel to the engine if attempts are made to start the vehicle without the correct bitted key. PASSLock increased the level of security while retaining the ease of service and costs offered by standard ignition lock systems.
How to reset the passkey II security system?
Passkey II Reset procedure. Passkey II reset procedure, reset security system on chevy, buick, oldsmobile, cadillac, pontiac, saturn, hummer Make sure the battery if fully charged because this procedure may take up to 30 minutes and you cannot start the vehicle during this time.
How to reset the passkey on a car?
1. Turn the key to ON, but do NOT start the vehicle. Leave the key ON for 11 minutes. The security light should be on steady or flashing during the entire 11 minutes. Do NOT proceed to the next step until the security light either turns OFF or STOPS FLASHING. 2. Turn the key to OFF for 30 seconds.
What’s the difference between vats, Passkey, and vats?
VATS, PassKey, and PassLock. The troubleshoot and reset procedures are different for each. PassLock seems to have the highest failure rate. So if you have a key WITHOUT a chip in it, chances are it’s a PassLock system. This article describes how to troublshoot and fix a PassLock system. But here are some more articles to help
Is there a way to bypass PassLock on a Chevy?
NewRockies.com has a solution for how to fully bypass the PassLock system in GM cars. This problem has popped up in the following Chevrolet generations. Most years within a generation share the same parts and manufacturing process. You can also expect them to share the same problems.
What is the PASSKey System on a GM car?
Some GM vehicles come with a factory-installed anti-theft system commonly referred to as the passlock or passkey. Due to glitches with these built-in security systems, GM owners may experience problems trying to start their vehicles.
Passkey II Reset procedure. Passkey II reset procedure, reset security system on chevy, buick, oldsmobile, cadillac, pontiac, saturn, hummer Make sure the battery if fully charged because this procedure may take up to 30 minutes and you cannot start the vehicle during this time.
1. Turn the key to ON, but do NOT start the vehicle. Leave the key ON for 11 minutes. The security light should be on steady or flashing during the entire 11 minutes. Do NOT proceed to the next step until the security light either turns OFF or STOPS FLASHING. 2. Turn the key to OFF for 30 seconds.
When to remove GM vats Passkey security system?
Seriously! Bypass and remove GM VATS PassKey and PassLock systems even if you still don’t have problems with them. If your car is more than 6 years old, it is only a matter of time before the worst happens – and the problem is that you never know when it’s going to happen… and where!