What is OBC on golf cart?

What is OBC on golf cart?

The OBC is is a small device that is wired into the golf cart that’s purpose is to regulate the batteries charge. As you use and drive your golf cart, the OBC records the amount of energy consumed and then directs the charger to replace exactly the amount of energy needed to fully replenish the batteries.

How do I check my club car OBC?

How to Test Club Car Precedent Controller?

1. Connect a voltmeter to the negative terminal on the battery.
2. Connect the voltmeter to the M terminal on the controller.
3. Push down on the golf cart pedal.
4. A clicking sound should be heard.
5. The batteries show a full charge.

Where is the OBC on a Club Car golf cart?

If you have an OBC(on board computer) the wire will come off of that negative wire and through the middle of a small box about 4″ inches square. The small box is the OBC. If your negative wire comes off of the batteries and directly to the motor or anywhere else it does not have an OBC.

What is a 2000 golf cart worth?

However, a $2,000-5,000 price range is a significant decrease from new cart prices. Typically, low-end new golf carts will cost about $4,000 while high-end carts can cost as much as $10,000.

How do you reset the OBC on a golf cart?

Resetting the OBC must be performed in this order:

1. Key switch to off.
2. Set forward/reverse to neutral.
3. Put tow/run switch to tow.
4. Disconnect the negative battery terminal from the battery pack.
5. Put the tow/run switch to run.
6. Put forward/reverse switch to reverse.
7. Put key switch to on.

How do you test a 48v golf cart charger?

Knowing how to test a golf cart battery charger is fairly simple. . You should check the amount of power your battery charger generates by connecting a voltmeter to the positive and negative clamps of the charger. The needle on the voltmeter will move from left to right to show the amps available.

Is there a reset button on a golf cart charger?

Ignition or Motor Issues Believe it or not, it may be as simple as pressing a reset button. Use a screwdriver to expose the motor. Look for a small red button located near the main power supply. Press the button and put your cart back together before hooking it up to charge.

How much is a 10 year old golf cart worth?

Street legal golf carts that are five to 10 years old usually go for $5,000 to $6,000. A standard cart that is five to eight years old normally sells for $2,000 to $4,000.

What makes a golf cart street legal?

Street legal golf carts should have basic safety equipment, including head lamps, stop lamps, front and rear turn signals, tail lamps, reflectors (one red on each side near the rear, and one red on the back), a parking brake, an exterior mirror, a windshield that meets state regulations, seat belts and a vehicle …

How do I reset my ezgo golf cart?

Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button. Push the button to reset the motor.

How do I reset the OBC on my EZ Go golf cart?

To reset the OBC the following must be done in this order:

1. Key Switch to Off.
2. Forward/Reverse to Neutral.
3. Tow/Run Switch to Tow.
4. Disconnect the Battery NEGATIVE (–) wire from the Battery Minus terminal on the battery pack.
5. Put the Tow/Run to Run.
6. Forward/Reverse Switch to Reverse.
7. Key Switch to On.

How can I tell what year my EZGO is?

Step 1: Look at the manufacturer’s code to determine the year of your EZGO golf cart The last two numbers of the manufacturer’s code is the model year of your EZ-GO golf cart manufactured from 1979 & up (it’s the first two numbers if manufactured from 1976-1978).

Where is the serial number on an EZGO 2Five?

And last, but not least, the EZGO RXV golf cart and 2FIVE Low Speed Vehicle have a serial number location unique to their models. They both feature a sticker located at the bottom of the steering column.

How to test the forward and reverse switch on an EZGO?

One of the EZGO buffs will be along soon to help you out with testing the forward and reverse switch on your golf cart. I always take them apart and check the contacts. You can usually tell by looking while the switch is still in the cart if the board has been hot. You can test the micro switches with a ohm meter.

What are the last two numbers on an EZGO golf cart?

The last two numbers of the manufacturer’s code is the model year for EZ-GO’s manufactured from 1979 & up (it’s the first two numbers if manufacturered from 1976-1978). Here are two examples: If the last two numbers of your EZ-GO manufacturer’s code are “92”, you own a 1992 EZ-GO Marathon.