What is high resistance in airbag?
Anything less than 2 Ohms, the SRS/Airbag module would indicate resistance too low, anything greater than 2 Ohms, the SRS/Airbag module would indicate resistance too high.
What does code B1346 mean?
B1346 – Driver Front Airbag Resistance Too High.
What does resistance to high mean?
Resistance measurements are normally taken to indicate the condition of a component or a circuit. The higher the resistance, the lower the current flow. If abnormally high, one possible cause (among many) could be damaged conductors due to burning or corrosion.
Can you measure the resistance of an airbag?
Oh, do not try to measure the resistance of an airbag directly; it may go “boom” if you do. driver side – side airbag fault is still related to the seat airbag you have replaced..
What kind of resistor do you need for airbags?
To defeat the airbag warning, use a 4.7 ohm 1/2 watt resistor for all airbags. Except the steering wheel where you use a 2 ohm . 5 watt. I got mine from Dick Smith Electronics
How many Watts Does a steering wheel airbag resistor need?
Steering Wheel Airbag resistor is 2 ohm .5 watt Seat Airbag resistors needed is 4.7 ohm .5 watt Passenger Airbag resistor needed is 4.7 ohm .5 watt Curtain Airbag resistors needed is 4.7 ohm .5 watt Seat Belt Tensioner resistor needed is 4.7 ohm .5 watt To defeat the airbag warning, use a 4.7 ohm 1/2 watt resistor for all airbags.
How to get rid of airbag code 9440027?
Clean the connectors and apply Stabilent 22A from VW as a contact enhancement or see Wurth SW and OL and OS Kontact additives. Thanks for the input. I reworked the connector under the seat and the code has now gone away.
Are there two codes for air bag resistance?
There are two codes, B1 481 driver air bag resistance too … read more Have error code -1511 and the air bag light on. Replaced the Have error code B-1511 and the air bag light on. Replaced the seat belt assembly with new part, and the airbag light stayed on.
How to test side mount air bag resistance?
Using a digital volt/ohm meter, test the resistance of the driver’s side, side mount air bag circuits between the ground and the driver’s side, side mount air bag squib connector. Reconnect the battery with the ignition on. Test the connection of the wiring harness and connectors by wiggling the wires and connectors, looking for looseness.
To defeat the airbag warning, use a 4.7 ohm 1/2 watt resistor for all airbags. Except the steering wheel where you use a 2 ohm . 5 watt. I got mine from Dick Smith Electronics
Is it safe to drive with the airbag light on?
No, the airbag control system is designed so that you have to erase the trouble code manually before the airbag light goes away. This is for safety purposes as I wrote before. To delete the trouble code, you have to use an OBD2 scanner. You have to use an OBD2 scanner that can search through the airbag system on your car.