What is FCC ID car remote?
An FCC ID on a car remote or wireless key fob is the regulatory certification number used to certify the fob (remote) complies to wireless emissions standards.
Where can I find the FCC ID for my car?
The FCC ID number will be found on the back of the key FOB.
What is IC ID?
The IC ID (sometimes just IC) is a wireless certification approval number for all devices sold within Canada. IC ID stands for Industry Canada Identifier. Devices with approved IC IDs will appear on the Industry Canada Radio Equipment List. Sometimes, the IC ID will be abbreviated to just IC.
Where is the ignition wire on a remote starter?
The ignition wire supplies power to the fuel pump and ignition system and will be attached to the ignition switch under the steering wheel. The vehicle manual or repair guides should tell you which color this wire should be. Connect the ignition output wire on the remote starter to this wire.
How to find your FCC ID or part number?
HOW TO FIND YOUR FCC ID OR PART NUMBER Check the back of your current remote to match the FCC ID# & Part# with the keyless entry you want to order – your old remote’s #’s and the one you want to purchase must match view diagramswatch tutorial video
Do you need a technician to install a remote starter?
Ideally, remote starters should be installed by a qualified technician because improper installation can damage expensive vehicle control electronics. However, for someone familiar with electronics and vehicle repair, knowing how to install a remote starter in a car can save money on installation costs…
How can I tell if my remote starter is in valet mode?
Certain remote starter manufacturers use a safety feature called valet mode. It is designed to temporarily disable the remote starting capability, but valet mode typically leaves the keyless entry function intact. One way you may be able to tell if your vehicle is in valet mode is by watching the parking lights.
What is the wiring diagram for a 1998 Blazer?
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 1998-2002 Chevrolet S-10 Blazer . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle.
Where are the fuse panels on a Chevy Trailblazer?
Here you will find fuse box diagrams of Chevrolet TrailBlazer 2002, 2003, 2004, 2005, 2006, 2007, 2008 and 2009, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
Certain remote starter manufacturers use a safety feature called valet mode. It is designed to temporarily disable the remote starting capability, but valet mode typically leaves the keyless entry function intact. One way you may be able to tell if your vehicle is in valet mode is by watching the parking lights.
Where is the dome light wire located on a blazer?
NOTE #3: The wires for the DOOR TRIGGERS and DOME LIGHT SUPERVISION are located at the BCM: The DRIVERS door wire is a TAN (-) B4 and the PASSENGER door is a ORANGE (-) B2 in the PURPLE Plug. For the REAR doors and REAR hatch use the DARK BLUE/WHITE B11 in the LIGHT BLUE Plug of the BCM.