What is a CV carb on Harleys?
A CV carburetor (Constant Velocity) incorporates a vacuum operated slide that varies the venturi size within the carburetor, thus maintaining a constant velocity. The slide also holds a needle that when lifted by the opening slide varies the amount of atomized fuel delivered.
How do you change the throttle cable on a Polaris Sportsman 500?
Adjust throttle cable freeplay at the handlebar.
- Locate the throttle cable. adjuster at the handlebar.
- Squeeze the end of the rub- ber boot and slide it far. enough to expose the end of.
- Loosen the adjuster lock nut.
- Rotate the boot to turn the. adjuster until 1/16″ to 1/8″
- Tighten the lock nut.
- Squeeze the end of the rub-
How to remove choke cable from Carb?
There should be a 12mm brass fitting into the carb, once removed the plunger should slid right out, if not soak it in PB blaster overnight atleast. Gentaly pull up on cable, if you can get a hold of the cable with needle nose that would be better, if it still wont come easy soak it some more with Rust eater.
How can I remove choke cables from a Kawasaki KLR?
P.S. I removed the seat and tank in order to have easy access to the right side of carb. If I remember correctly, I just used (gulp) a good pair of pliers. It just needed something that could grip it to break it loose. I installed a KLX250 choke plunger knob on my choke to eliminate the cable and it worked perfectly.
Where does the choke Cable go on a motorcycle?
You need to have the motorcycle secure in order to remove the choke cable. To do this, you should put it on a lift. Failing that, you can also use a motorcycle jack or even just have it on the kickstand, although you won’t find it as stable. The choke cable runs from the handlebars of the motorcycle into the engine, specifically to the carburetor.
Can a choke cable be removed from a carburetor?
You should now be able to unhook the choke cable from the carburetor. With one end of the choke cable free, you’ll now be able to pull it along the frame, removing an brackets that might impede it. When it’s free, unbolt the locking clips at the back of the handlebars and pull the choke cable through.
How can I remove choke from my bike?
You will also need to walk around to the other side of the bike and remove the choke or enricher cable from the bracket so you can pull it out through the carburetor side of the bike. 8.) You can do step 8 before 7 if you want but the vacuum hose is sometimes tight as is the choke/enricher cable so use your best judgement.
How do you remove a carburetor from a throttle cable?
You can now see the carburetor being held by the throttle cable. To remove the throttle cable, first pull the rubber on the cable. Then unscrew the locknut, which is closest to the carburetor, from the throttle cable.
P.S. I removed the seat and tank in order to have easy access to the right side of carb. If I remember correctly, I just used (gulp) a good pair of pliers. It just needed something that could grip it to break it loose. I installed a KLX250 choke plunger knob on my choke to eliminate the cable and it worked perfectly.