What is a camshaft position sensor A circuit Bank 2?
The CMP sensor measures the exact rotational position and speed and position of the camshaft. The data that the CMP gathers is important because it’s used by the ECM to control the ignition spark and the fuel injector timing.
What does the p0345 Ford Circuit Bank 2 mean?
P0345 FORD | Camshaft Position Sensor ‘A’ Circuit Bank 2 | The Camshaft Position Sensor is an electronic device used in an engine to record the rate at which the camshaft is spinning. This information is used by The Camshaft Position Sensor is an electronic device used in an engine to record the rate at which the camshaft is spinning.
What does p0345 code-camshaft position sensor a circuit?
This indicates that a problem was detected in the camshaft position sensor circuit of bank 2. Since it says circuit, that means the problem could lie in any part of the circuit – the sensor itself, the wiring, or the PCM. Don’t just replace the CPS (camshaft position sensor) and think that will definitely fix it.
How long does it take to diagnose a Ford p0345 code?
Sometimes and in some models, low battery voltage or a weak starter can trigger a Camshaft Position Sensor code. The cost to diagnose the P0345 FORD code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.
What does Bank 2 mean on a Ford F150?
It is usually caused by a wiring problem or the CPS itself. OBDII P0345 means that there is a problem with the Camshaft Position Sensor (CPS) circuit “A”. Bank 2 indicates that it’s on the side of the motor with the second cylinder in the firing order.
What causes the p0345 code on a Ford F150?
As stated above, the P0345 code is often caused by a failure in the Camshaft Position Sensor itself. Here are the most common causes: Wiring Issue – The Camshaft Position Sensor wiring is exposed to harsher conditions than a lot of the wiring in your F150.
What does the DTC code p0345 stand for?
Diagnostic trouble code (DTC) P0345 stands for “Camshaft Position Sensor “A” Circuit (Bank 2).” This code refers to an issue in the camshaft position sensor (CMP) circuit of the engine’s bank 2, which is the bank not containing cylinder #1.
What causes the p0345 CMP sensor to malfunction?
P0345 – Camshaft position (CMP) sensor A, bank 2 circuit malfunction Trouble Code Fault Location Probable Cause P0345 Camshaft position (CMP) sensor A, bank 2 Wiring, CMP sensor, ECM
It is usually caused by a wiring problem or the CPS itself. OBDII P0345 means that there is a problem with the Camshaft Position Sensor (CPS) circuit “A”. Bank 2 indicates that it’s on the side of the motor with the second cylinder in the firing order.