What is a camshaft plug?
The camshaft seal is a round oil seal located in the cylinder head. It is responsible for sealing the end of the engine’s camshaft or camshafts between the top of the cylinder head and the valve cover gasket. Camshaft seals are usually made of durable rubber materials that allow them to have a long service life.
How to replace an oil seal with the shaft still in the case?
How to replace an oil seal with the shaft still in the case. – YouTube How to replace an oil seal with the shaft still in the case. If playback doesn’t begin shortly, try restarting your device.
How do you change the oil in a Honda CRV?
Keep rags or towels nearby to wipe up any spills. Use a 17 mm socket, or box end wrench, to loosen the oil drain plug by turning it counter-clockwise until you can turn it by hand. Finish removing the oil drain plug by hand.
How do you replace a rear engine seal?
Using a large standard screwdriver gently pry the housing loose from the engine block. As you work around the edges of the housing lift with your other hand using a rocking motion. It can be a little stuck because the housing is mounted on dowels in the block. Now the housing will come loose from the engine block.
What does a rear crankshaft seal look like?
Here is what the seal retainer looks like when removed. It is a simple plastic ring that pushes into place once the seal in installed. This retainer is designed to keep the seal from moving while in operation. Now remove the rear main seal by hand from the crankshaft hub. 8. Match the New Rear Crankshaft Seal
What’s the best way to replace a camshaft seal?
Pry the camshaft seal out using a screwdriver or dedicated oil seal puller (there are a variety available). Note: Be careful not to scratch the camshaft during this step of the seal will leak. Step 1: Prepare the sealing area. Spray brake clean into the sealing area and wipe it clean with a paper towel or lint free rag.
Keep rags or towels nearby to wipe up any spills. Use a 17 mm socket, or box end wrench, to loosen the oil drain plug by turning it counter-clockwise until you can turn it by hand. Finish removing the oil drain plug by hand.
Where is the oil drain plug on a Honda CRV?
Locate the 17 mm hex oil drain plug. It is on the driver’s side of the car facing backwards. Place the oil drain pan under the oil drain plug. Be sure to position the drain pan so that it will catch the oil when it is streaming out of the pan.
What’s the best way to remove a camshaft sprocket?
Use a camshaft sprocket holding tool to hold the sprocket in place. Then, remove the sprocket bolt using a long ratchet and socket or a breaker bar. Note: If the camshaft sprocket is not held properly, the camshaft may spin causing, engine damage.