What is a broken drive shaft?
A broken driveshaft can prevent wheels from turning properly, giving you trouble when trying to make turns. This issue limits your overall control of the car. You need any issues that prevent you from driving the car correctly addressed right away for safe driving and continued use of the vehicle.
How much does a Mercedes flex disk cost?
If you do it yourself you can spend around $100 for the Mercedes-Benz Genuine flex disk. If you would like to save even more there are many aftermarket flex disks for Mercedes-Benz for well under $100 USD.
What kind of coupling device is Mercedes flex disc?
A flex disc or a giubo is a coupling device made of hard rubber. Input and output shaft flanges are bolted to the Mercedes Flex Disk on either side (see picture below).
What causes a Mercedes flex disc to wear out?
Mercedes Flex Disk Causes 1 Car age. The older the car gets, the more degradation happens. 2 Heat and other elements. Since a flex disc is made of rubber, heat and other harmful elements slowly wear it out. 3 Alignment of drivetrain. When a drivetrain is misaligned, it will cause too much stretch on the flex disc causing the… More …
How much does it cost to replace a Mercedes drive shaft?
Replacing the Mercedes-Benz drive shaft at the dealer can range from $800 to $2000 depending on the Mercedes-Benz model. You can buy the part from the dealer or online and have an independent repair shop install it. The cheapest option is to buy a used propeller shaft from another vehicle and install it yourself.
If you do it yourself you can spend around $100 for the Mercedes-Benz Genuine flex disk. If you would like to save even more there are many aftermarket flex disks for Mercedes-Benz for well under $100 USD.
Where are the driveshaft bolts located on a Mercedes?
Locate the driveshaft bolts at the cv joint. Note that Mercedes-Benz typically uses constant velocity (CV) joints at the driveshaft and not universal joints. Remove them one at a time. Note that you may need to turn the driveshaft to get to the top bolts.
What should the torque be on a Mercedes drive shaft?
Tighten the bolts on a cross pattern to the specification. The typical torque specification is 40 Nm, but you should verify this value by calling the dealer. Once you are done installing all the bolts, give them a 90-degree turn to finish the installation.