What happens when camshaft position sensor goes bad?
Poor Drivability A failing camshaft position sensor begins losing its ability to quickly transfer data. Mismatched fuel delivery and ignition timing, even if off by a few milliseconds, will cause your vehicle to sputter, accelerate poorly, lack power, stall or even shut off.
What is fault code P0010?
What the P0010 code means. P0010 is a generic OBD-II code indicating an issue with the engine control module (ECM) detecting a variation in the mechanical timing between the crankshaft and bank 1 camshaft. From these sensor signals, the ECM controls ignition, valve lift, and fuel timing under various speeds and loads.
What is P0010 code?
Code P0010 is triggered when the ECM attempts to adjust the Bank 1 intake camshaft timing by utilizing one of these valves, and it detects an electrical issue in either the circuit going to the valve or the windings of the solenoid in the valve itself.
How do I fix error code p0010?
Check freeze frame data relating to the ECM to help pinpoint the exact issue. Do a visual inspection of the bank 1 variable valve timing (VVT) control solenoid valve. Make sure to repair any frayed or faulty wiring or connectors. Once you have done this, clear the code and rescan to see if it is still present.
What are the causes of a p0010 code?
What Is The Cause Of Code P0010? 1 Faulty VVT control solenoid valve (most common) 2 Oil sludge in the engine 3 Crankshaft position sensor malfunction 4 Camshaft position sensor malfunction 5 Frayed or damaged wiring 6 Engine operating outside of proper timing parameters More
What to do if your check engine light says p0010?
Check to see if there are any other codes along with P0010 and clear your Check Engine Light with FIXD. Check freeze frame data relating to the ECM to help pinpoint the exact issue. Do a visual inspection of the bank 1 variable valve timing (VVT) control solenoid valve. Make sure to repair any frayed or faulty wiring or connectors.
What causes an error on the camshaft position actuator?
The following are among the most likely causes for this error: Fault connector of the camshaft position actuator (corroded, loose, or bent, or disconnected pins) Before you attempt to diagnose this error code, make sure that you have some knowledge regarding safety measures as you work with your car.