What happens if your clutch cable breaks on motorcycle?

What happens if your clutch cable breaks on motorcycle?

A broken clutch cable or a broken lever will sure give you some headaches. Fortunately, the motorcycle gearbox can handle a lot of badass gearshifts. You don’t have to worry. It’s not difficult, and all you only have to do is to focus on the throttle.

Where do you disconnect the clutch cable in a car?

Disconnect the cable at the gearbox end. It is fixed to the clutch-release lever by nuts which also provide adjustment. Move the clutch pedal by hand. You should be able to feel whether the cable slides smoothly. If it does not, the cable may be bent at too sharp an angle by being wrongly routed.

How often should I Check my Clutch cable?

The clutch cable has a steel-wire inner core sliding inside an outer sheath. It should last at least two years, but check it at every main service; if it breaks it may do so without warning. The heavy clutch-pedal pressure needed to work it may conceal any initial stiffness or stickiness in the cable itself.

Why does my clutch cable keep breaking on my car?

The heavy clutch-pedal pressure needed to work it may conceal any initial stiffness or stickiness in the cable itself. The exposed cable ends are the parts most likely to fray and break, especially at the gearbox end. To check or replace the cable, support the car on ramps or axle stands and chock the wheels on the ground .

Where does the cable end on a clevis pedal?

Disconnect the gearbox end first and remove the nuts; then free the inner cable from the pedal. It may have a loop which fits over a hook at the top of the pedal; pull the cable slack and lift it off. The cable may end in a fork pivoted on the pedal by a clevis pin.

What are the symptoms of a bad clutch cable?

2. Hard clutch pedal Another symptom of a problem with the clutch cable is a hard clutch pedal. A jammed or stuck cable will not be able to move when the pedal is depressed and will result in a pedal that resists depression when stepped on.

What is a cable clutch?

A clutch cable is the steel braided cable found on manual transmission vehicles that connects the transmission clutch linkage to the clutch pedal mechanism. When the pedal is depressed, the clutch cable pulls on the clutch linkage to disengage the clutch so that the transmission can be safely shifted.

When to replace the clutch cable in a manual car?

If your manual car’s transmission is slipping out of gear or clutch pedal is hard or sinking to the floor, you may have to replace the clutch cable. 1. Transmission slips out of gear 2. Hard clutch pedal 3. Clutch pedal sinks to the floor Average rating from 130,908 customers who received a Vehicle Drivetrain Inspection.

Where is the clutch cable adjuster nut located?

Locate the clutch cable housing adjusting nut, locknut (or wingnut), and adjuster nut at the cable bottom end where it attaches to the clutch operating lever. To increase clutch pedal free travel (lower clutch pedal), shorten the housing by turning the nut.