What does the SRS light on a Honda CRV mean?
A Honda CRV comes with an On-Board Diagnostics computer that keeps track of all the mechanical functions of the vehicle. When you see the SRS light flash on your instrument panel, it is alerting you to a malfunction in the Supplemental Restraint System, i.e., the airbag system. Put on safety goggles and cloth work gloves.
What does the airbag warning light on a Honda CRV mean?
The supplemental restraint system light, otherwise known as the airbag warning light stays on when there’s a problem detected with the Honda CR-V restraint system. The fault may cause any of the following to not initial during a vehicle impact: Have the system serviced as soon as possible.
Why does the blind spot monitor come on on a Honda CRV?
The Honda CR-V blind spot alert system is designed to detect and alert you of vehicle in the alert zones adjacent to your vehicle. The blind spot monitor warning light comes on for the following reasons: ▷ Warning light remains on when the system has been switched off.
Why does my Honda SRS light keep blinking?
The SRS light will blink twice indicating the SRS system and the light are reset. If this procedure is followed correctly and the light remains on, then there may be an actual issue with the SRS system. In this case, it is advised to bring the vehicle to the dealership, where the trouble code can be identified and the issue repaired.
Why does my Honda SRS light not reset?
The SRS light may indicate a problem with a sensor in the steering wheel, seat, or onboard computer. But even if you discover the reason for the problem, the light does not reset itself.
What does SRS stand for in Honda Civic?
Learn how to do so here. This article applies to the Honda Accord (1990-2002) and Honda Civic/Del Sol (1992-2000). The secondary restraint system, or SRS, is a safety system in your Honda that controls the airbags, among other things.
Where is the SRS unit on a Honda Accord?
The SRS unit is mounted on the floorboard near the firewall, which is behind the stock radio. To access the unit, remove the center console and two side panels. There is one screw and one clip on the driver’s side. There are two clips on the passenger’s side.
How do you turn off the SRS light?
MES connector with “short” wire. With this connection made, turn the ignition key to the “on” position (do not start the engine). The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again. When it does, reconnect the shorting wire.
Is there a way to reset the SRS light?
That’s partially true; however, having the SRS light come on during Honda ownership is almost an expected thing. Having the SRS light come on is so common that the original owner’s manual actually gives a briefing on how to reset it. To do so, you will be “shorting” the system in order to reset the light.
Where is the MES plug on a Honda CRV?
Put on safety goggles and cloth work gloves. Find the MES connector under the steering wheel near the fuse box. It is generally green or yellow and has a two-hole holder plug in its place. Remove the plug. Strip the ends of both wires using a knife. Put one end of each of the wires into each of the holes of the MES connector.
What should I do if my SRS light keeps coming on?
If you don’t have wires, you can use paperclips instead. Hold the ends of both wires together, and turn on the ignition. The SRS light will come on, and after a few seconds it will turn off. Once the light turns off, pull the wires apart. The light should turn back on. Hold the stripped ends of both wires together again.
How do you turn off the SRS light on a Honda CRV?
Strip the ends of both wires using a knife. Keep the ends of the wire touching while you do this. Repeat Step 3 and the SRS light will blink twice and turn off. Unshort the two wires. This will cause the SRS light to blink twice.
The SRS light will blink twice indicating the SRS system and the light are reset. If this procedure is followed correctly and the light remains on, then there may be an actual issue with the SRS system. In this case, it is advised to bring the vehicle to the dealership, where the trouble code can be identified and the issue repaired.
What happens when you turn off the SRS light?
The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again. When it does, reconnect the shorting wire. The SRS light will turn off. Disconnect the shorting wire.
How can I reset the SRS light on my car?
Take care not to touch the exposed wire with any part of your body. Put the key in the ignition and turn it on, but don’t start the engine. Keep the ends of the wire touching while you do this. The SRS light will flash on, and then disappear. Separate the wires immediately. The SRS light should come on again.
Where is the memory erase signal on a Honda?
Locate the MES (Memory Erase Signal) connector. It is below the dashboard on the driver’s side of the car plugged into a panel (there is no electrical connection). Figure 1. MES location under the dash. In this step, you will internally make the connection in the plug to “short” it.
A Honda CRV comes with an On-Board Diagnostics computer that keeps track of all the mechanical functions of the vehicle. When you see the SRS light flash on your instrument panel, it is alerting you to a malfunction in the Supplemental Restraint System, i.e., the airbag system. Put on safety goggles and cloth work gloves.
What does the airbag warning light on Honda CRV mean?
Every time you start your Honda CR-V, the computer system runs a self diagnostic check on all major systems. If any of these checks fail, you will see a diagnostic warning light on the dash for the corresponding system. When the airbag system fails this check, you’ll see the airbag light.
What are the DTC codes for Honda SRS airbags?
Honda SRS Airbag DTC Codes. 1 Honda 1988-2002 All Models Codes: 1-1 & 1-2 open circuited Or high Resistance In Drivers Air Bag Inflator 1-3 short circuited To Another Wire In 2 Honda 2002-2011 All Models Codes: 3 Honda CIVIC, CR-V, ELEMENT & RIDGELINE Codes: 4 Honda ODYSSEY Codes: 5 Honda INSIGHT, PILOT S2000 Codes:
When to do TPMS re-calibration on Honda CRV?
However, for indirect TPMS systems on the Honda CR-V for mid-year 2014-2019, a TPMS re-calibration is recommended when changing air pressure, rotating tires and replacing a tire or TPMS sensor. Use the VT56 to retrieve Honda TPMS DTC codes for direct TPMS systems by selecting the “Service” icon.