What does the p0101 Nissan MAF sensor mean?
P0101 NISSAN Meaning The Mass Air Flow (MAF) sensor is placed in the stream of intake air. It measures the intake flow rate by measuring a part of the entire intake flow. It consists of a hot film that is supplied with electric current from the Engine Control Module (ECM). The temperature of the hot film is controlled by the ECMa certain amount.
Why does my Nissan Juke have p0101 on it?
Clogged Catalytic Converter – If you are getting P0101 in your Juke accompanied by a noticeable lack in power at speed, it may very well be that you have a clogged catalytic converter Whatever the reason for P0101 in your Nissan Juke, ignoring it is a bad idea.
Why is my MAF sensor not working on my Nissan Juke?
With the Nissan Juke, P0101 means the the Mass Air Flow (MAF) sensor has a Range/Performance problem. We will cover exactly what that means and potential fixes for it below. It should be considered a high priority to fix, as the MAF sensor not reading properly can really make an impact on the performance…
What to do if your car has a p0101 code?
Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. P0101 NISSAN Tech Notes Before replacing the Mass Air Flow (MAF) Sensor, try replacing the air filter and cleaning the air flow sensor with low compress air or mass air flow sensor cleaner. Reset code and drive vehicle.
What does trouble code p0101 mean on Nissan?
A P0101 Nissan trouble code is very common and there are two fixes for it. A P0101 trouble code is defined as P0101 for Mass Air Flow sensor (MAF) stored in the ECM. That may lead you to automatically replace the MAF.
With the Nissan Juke, P0101 means the the Mass Air Flow (MAF) sensor has a Range/Performance problem. We will cover exactly what that means and potential fixes for it below. It should be considered a high priority to fix, as the MAF sensor not reading properly can really make an impact on the performance…
What causes the MAF sensor to throw p0101?
Intake Manifold/Vacuum Leak – If there is a leak in the intake manifold, it will be impossible for the MAF sensor to get an accurate reading. Without knowing how much air is really getting into the engine, P0101 will be thrown. MAF Sensor Wiring – Make sure to check around the MAF sensor for opens or shorts.
What is the error code on the MAF sensor?
I checked the error code using OBD2, and the code was P0101. I bought MAF sensor cleaner and a new air filter (the old air filter was very dirty). After cleaning the MAF sensor, I replaced a new air filer.
Clogged Catalytic Converter – If you are getting P0101 in your Juke accompanied by a noticeable lack in power at speed, it may very well be that you have a clogged catalytic converter Whatever the reason for P0101 in your Nissan Juke, ignoring it is a bad idea.
What does Mil code p0101 mean on Nissan Altima?
My 2013 Altima with 78,5xx miles finally had its first problem — MIL lamp illuminated, code P0101. This indicates a MAF sensor fault. I installed a K&N filter over a year ago, so I assume some of the oil may have made its way to the wire sensor on the MAF.
What to do if you get code p0101 on your MAF sensor?
I cleared the code and started and drove the vehicle three times since, and the problem appears to be resolved. tl;dr: If you get code P0101 in your Altima, go spend $5 on a can of MAF cleaner before replacing the sensor. I get that code every so often, I just clear it.