What does the flashing hold light mean on a Mazda 626?
Hello, The flashing “Hold” light indicates there is something wrong with the transmission system. Best of luck! CarGrrl 26 people found this helpful. For our 626’s, it means that the electronic transmission controls are no longer being used to control the transmission.
What does the car and lock symbol on a Mazda 2 mean?
The car and lock symbol is the Mazda 2 security indicator light and it flashes every 2 seconds indicating that the vehicle immobiliser system is armed. If the security indicator light flashes continuously when you’re driving, a fault has been detected with the system. What to do: Do not turn off the engine as you will be unable to restart it.
When does the I stop light go out on a Mazda 2?
‘i-stop’ is Mazda’s version of start / stop technology to help improve fuel economy and reduced exhaust gas emissions. The mazda 2 amber i-stop warning light illuminates when: • The ignition is switched on, but should go out shortly after engine startup. • The bonnet is opened when the system is in engine stop mode.
What does the amber warning light on a Mazda 2 mean?
If the Mazda 2 i-ELOOP amber warning light comes on, a fault has been detected with the system. Have the i-ELOOP system serviced by a Mazda workshop. The Mazda 2 AT warning light illuminates in orange when a fault has been detected with the Automatic Transaxle, or Automatic Transmission. This includes the transmission, axle, and differential.
What does the temperature warning light on a Mazda 2 mean?
This is the Mazda 2 engine coolant light. It illuminates in blue continuously until the engine is at optimal running temperature then goes out. It illuminates in red to indicate that the engine coolant is too high and that the engine is overheating. The temperature warning light may flash or illuminate steady.
What to do if your Mazda dash light goes off?
It’s advised to pull over, switch off the engine and contact a Mazda workshop. If you cannot pull over and stop immediately, switch off any non-essential devices that consume electric as this may help to prolong engine activity.
Why does my Mazda 626 keep flashing while driving?
Most likely due to overheating or a problem with the speed sensor. On my 626 I can often stop it by shifting into nuetral while driving, turning the car off (while in motion) and then turning it back on. I have also heard that disconnecting the battery cable (when the car is parked 😉 ) and holding in the brake petal for 30 seconds can help.
The car and lock symbol is the Mazda 2 security indicator light and it flashes every 2 seconds indicating that the vehicle immobiliser system is armed. If the security indicator light flashes continuously when you’re driving, a fault has been detected with the system. What to do: Do not turn off the engine as you will be unable to restart it.
How can you read the transmission code on a Mazda?
Automatic transmission codes can be read by connecting the TAT and GND pins (see above for the location of this pin) and watching the “hold” light on the instrument cluster.
Why does the Mazda overdrive light keep blinking?
The light may blink continuously, even if the driver is maintaining average speeds when the panel light should remain steady. Additionally, Mazda drivers report issues with being unable to manually turn off the overdrive feature, sometimes causing further issues as a result of the overuse of overdrive including fuel transmission problems.
Why does my Mazda 323 have a flashing orange hold light?
Recently my car’s dash has been displaying a flashing orange “HOLD”. It doesn’t happen all the time (twice in the last 2 or 3 weeks that I can think of) and the length of time it stays on for varies as well. I’ve checked Google for a bit of info, and I understand its a problem with the transmission, though I can’t get much more than that.