What does the code P2106 stand for?

Code P2106 is set by the PCM to force the Throttle Actuator Control System to limit the power level of the engine.

What is the OBD II fault code p0638?

OBD II fault code P0638 is a generic code that is defined as “Throttle actuator control, Bank 1 -range/performance problem”, and is set when the PCM (Powertrain Control Module) detects a problem with the operation of the throttle control actuator on drive-by-wire systems.

What causes a throttle actuator to set code p0638?

Common causes of code P0638 could include the following-. Damaged, burnt, shorted, corroded, or disconnected wiring and/or connectors. Note that wiring issues in almost any part of the CAN bus system that is involved in throttle control can cause this code to set. Defective throttle actuator.

What is the PCM forced limited power code?

Code P2106 is set by the PCM to force the Throttle Actuator Control System to limit the power level of the engine. This code can be related to a Throttle Actuator Control System malfunction, but normally another issue is setting this code.

Is there a cause for the code P2106?

As stated elsewhere, the cause (s) of code P2106 does not have to involve the throttle control system, except in cases where it is certain that there are no other codes present along with P2106.

Why is my throttle actuator code P2106 set?

Code P2106 can be generated without an error to the throttle actuator. The code is set due to another system has failed and caused the ECM to go into failure mode. All other codes should be checked and repaired first. Need help with a P2106 code?

What does p0639 mean on a throttle body?

This code is similar to code P0639. Most throttle bodies of this type are not serviceable and need to be replaced. The throttle body is spring actuated to hold at an open position in the event of a motor failure, in some cases with a complete failure the throttle will be unresponsive and the vehicle will only be capable of driving at a slow speed.

What are the symptoms of the P2106 OBD-II trouble code?

The throttle actuator control (TAC) system is limited on power and code P2106 is set. Problem may be in any system that can cause the ECM to go into failure management mode. What are the symptoms of the P2106 code?

What does P2106 mean on a throttle actuator?

This code may be related to Throttle Actuator Control System malfunction, but in many cases, there is another issue that sets this code. P2106 is triggered when the PCM receives an abnormally signal from different components.

What does the P2106 code on a Ford TAC mean?

The P2106 code is set when the TAC system is in the Failure Mode Effects Management (FMEM) mode of forced limited power. The P2106 indicates the FMEM action is in effect due to a concern in an Electronic Throttle Control (ETC) related component or module.

Code P2106 is set by the PCM to force the Throttle Actuator Control System to limit the power level of the engine.

What is the DTC code for OBD-II?

This generic powertrain diagnostic trouble code (DTC) typically applies to all OBD-II equipped vehicles that use a drive-by-wire throttle control system including but not limited to vehicles from Ford, Mercedes Benz, Mazda, Kia, Hyundai, Dodge / Ram, Land Rover, VW, Jaguar, tc.

Navigation