What does res mean on fuel switch?
At ‘RES’ position in the reserve fuel switch, the fuel from the reserve tank is free to move to the carburetor and then to the engine. This is the position you want the reserve fuel switch to be in when you have run out of fuel in the main tank.
Should you turn fuel off on motorcycle?
Yep, It is advisable to turn off Fuel when you are parking your bike for longtime as most of the motorcycles fuel ⛽ tank is higher than the carburetor which makes the continuous flow of fuel to carburetor to from fuel tank when if carburetor failed to close the valve gas would continue to trickle into carburetor which …
What does PRI mean on fuel tap?
PRI is for priming the carburetor. That means filling the carburetor up with gas if it is say the first time its ever been ridden or the gas was drained out for some reason.
What does PRI mean on fuel petcock?
ON-RESERVE-PRI. ON is on. Reserve is reserve and PRI is Prime. Prime bypasses the diaphragm so you can fill the carbs with gas after they have been drained. Set it on PRI, fill the carbs and put it back to ON.
Why does the fuel selector go to reserve?
Some riders feel that using the “reserve” setting uses the fuel at the bottom of the tank preventing water from accumulating which could result in the tank rusting. a slight addition to this: on many bikes, leaving the selector in the reserve position may cause fuel to drip out onto the floor continually until the tank is empty.
What happens when you run out of fuel?
Then, you turn the valve to the “reserve” position and finish running the fuel out of the tank. This is why it’s important to turn the valve back to the “on” position after you refill the tank. If you don’t it will run all the fuel out and you won’t have any in the “reserve” position when you run out.
How does reserve fuel work on a Honda ATV?
So if you have it in the “on” position, once the fuel gets down below the top of the tube, it will run out of fuel. Then, you turn the valve to the “reserve” position and finish running the fuel out of the tank. This is why it’s important to turn the valve back to the “on” position after you refill the tank.
When to use reserve fuel on a two wheeler?
Use the reserve fuel only when the main supply is exhausted. Refill the tank as soon as possible after switching to “RES” position. The reserve fuel supply is specified as per our model. Do not operate the two-wheeler with the fuel valve in the “RES” position after refilling, you may run out of fuel, with no reserve.
Some riders feel that using the “reserve” setting uses the fuel at the bottom of the tank preventing water from accumulating which could result in the tank rusting. a slight addition to this: on many bikes, leaving the selector in the reserve position may cause fuel to drip out onto the floor continually until the tank is empty.
Then, you turn the valve to the “reserve” position and finish running the fuel out of the tank. This is why it’s important to turn the valve back to the “on” position after you refill the tank. If you don’t it will run all the fuel out and you won’t have any in the “reserve” position when you run out.
So if you have it in the “on” position, once the fuel gets down below the top of the tube, it will run out of fuel. Then, you turn the valve to the “reserve” position and finish running the fuel out of the tank. This is why it’s important to turn the valve back to the “on” position after you refill the tank.
Use the reserve fuel only when the main supply is exhausted. Refill the tank as soon as possible after switching to “RES” position. The reserve fuel supply is specified as per our model. Do not operate the two-wheeler with the fuel valve in the “RES” position after refilling, you may run out of fuel, with no reserve.