What does p0446 do to the EVAP system?
During the leak test, the ECM closes the vent control valve to create a sealed EVAP system. When P0446 is triggered, the ECM has detected a short in the circuitry to activate the vent control valve, or the EVAP system failed to maintain the proper pressure during the active EVAP leak test. What Are The Symptoms Of P0446?
What to do if your car has code p0446?
Gas caps are relatively inexpensive and are often the fix for code P0446. If the fuel cap didn’t fix it, perform an EVAP system leak check: Pinch off the vent tube to the EVAP Vent Control Valve. Pressurize the EVAP system with an EVAP smoke machine leak checker.
Why does p0446 cause fuel tank to crack?
Building their nests in the vent line blocks the flow, some of them so bad that they cause EVAP DTCs to be set, including P0446, and some so bad that they’ve caused canisters and fuel tanks to crack.
What happens when the EVAP valve is stuck?
In most cases, you will not notice any symptoms other than the MIL and slightly reduced engine performance and fuel economy, depending on whether the ECM goes into “limp-home” mode or not. If the EVAP vent control valve is stuck open, you may notice a fuel odor. This DTC may be accompanied by other EVAP system DTCs.
What causes an EVAP system code p0446?
Here are the most common causes of an EVAP System Malfunction or code P0446: 1 Malfunctioning vent control valve 2 Clogged vent valve 3 Control circuit issues (e.g., loose or damaged wiring) 4 Powertrain control module hardware or software issues (rather uncommon)
What causes the p0446 code on a Chevy Blazer?
Vapor Canister Purge Valve – One of the most common causes of the P0446 code is the vapor canister purge valve. It’s really easy to replace. There are a few clips that you need to find and remove. EVAP System Hose – The hose that carries the fuel vapor from the fuel tank to the intake manifold can begin to leak. This will cause the P0446 code.
What does p0446 mean on a fuel pump?
Scan your vehicle to verify P0446 is the only code present. If other codes are present regarding fuel pressure or the fuel system, repair and diagnose those first. If it is paired with P0441, P0440, and/or P0446 there is most likely a solenoid failure, leaking charcoal canister, or a more complex EVAP leak.
When to repair a check engine light p0446?
The driver will likely not notice any symptoms associated with P0446 other than the check engine light being on. However, as with all check engine light diagnostic trouble codes, you should repair it as soon as possible to return the vehicle to normal operation. Scan your vehicle to verify P0446 is the only code present.