What does it mean when your service 4WD comes on?
Vehicles that have four wheel drive systems tend to have a separate light to indicate an issue with the system. Usually labeled “Service 4WD”, when this light comes on, a code will be stored in the computer’s memory to help identify any issues. Depending on the problem, the four wheel drive may be disabled temporarily.
How do I turn off SERV 4WD?
Cheap way – To clear the codes and reset the computer, pull the 5 amp TCCM fuse, located at the bottom of the fuse box. Wait at least a half hour, and then replace the fuse. Turn the ignition key to run, wait for the 4×4 lights to blink, and then turn off. Repeat 5 times, and then start the truck.
Why does my jeep keep saying perform service?
The Jeep Grand Cherokee limits the service-required message to indicate the routine maintenance needs of the vehicle. The light needs to be manually reset when the indicator turns on. The process takes about 20 seconds for you to complete in case they forget to reset the light.
What do you do when your service 4WD light comes on?
Take vehicle to 4WD repair shop as soon as possible since this problem will happen again without warning. Problem: 4WD warning light flashing on, then goes out at startup. Cause: If the light stays on, or the “Service 4WD System” message is displayed, there is a problem with the 4WD system.
How do I get rid of Jeep perform service?
Check your owners manual for specific details.
- Turn on the engine.
- On the vehicle’s dash, press the “Step” button until “Miles to Service” is displayed.
- Press and hold the “Reset” button, near the “Step” button, until the “Miles to Service” flashes and resets. Verify the “Perform Service” light goes away.
How do you reset the perform service on a 2006 Jeep Grand Cherokee?
Locate the “Step” button on the Grand Cherokee’s instrument panel and press it. Press it again until it says “Miles to Service.” Press in and hold the button for about five seconds. It should read “Reset.” This will turn off the service light on the display.
What does perform service mean on a 2006 Jeep Grand Cherokee?
suggested maintenance service
Needs to perform the manufacturer’s suggested maintenance service. It could be as simple as an oil and filter change – based on mileage and previous maintenance records. After the service the repair shop will reset the warning light.