What does f1 mean on my Suzuki GSXR?
SOURCE: on a 2004 suzuki gsxr. FI stands for Fuel Injection. The fuel system sensors have detected a problem. It could be anything > a dirty air filter FI stands for Fuel Injection.
How do you clear f1 code on GSXR 125?
Fi codes can be reset by jumping the pins on the white service plug under the pillion seat. It is a white plug with grey foam on it, under pillion seat on right hand side (If you are sitting on it). Turn on ignition and then off, then on again.
How do you get Fi code flashing on Suzuki GSX-R?
With your key in the ignition and bike turned to “on” (but not running), take a paperclip and short the two connectors out (by touching the two contacts together). This is known as a “ghetto dealer mode switch”.
What is the F1 code on a Suzuki GSXR 1000?
Click to expand… This is weird, after riding my 2002 GSXR-1000 over 19,000 miles I get the F1 code C46. I follow the directions according to the link which the white connection was still plugged up to the Servo and splice the other two wires B/R & R/B. Code is gone which I tested this after for over 1 hour.
What is the c00 code on a 2005 GSXR1000?
On 2005 GSXR1000 when I install the jumper I get the C00 code. How do I get rid of the F1 and light if nothing is wrong?Looked through everything listed and I did not see anything about it.
What does Fi mean on Suzuki GSXR 2006?
After riding over 10,000 miles on my 2006 750, FI started to show instead of temperature… (only) sometimes. Took it to dealer who said it needed to adjust exhaust valve (the wires) – as the error was shown because the valve did not fully close. 8,000 more miles since then and no problem. ..
Click to expand… This is weird, after riding my 2002 GSXR-1000 over 19,000 miles I get the F1 code C46. I follow the directions according to the link which the white connection was still plugged up to the Servo and splice the other two wires B/R & R/B. Code is gone which I tested this after for over 1 hour.
With your key in the ignition and bike turned to “on” (but not running), take a paperclip and short the two connectors out (by touching the two contacts together). This is known as a “ghetto dealer mode switch”.
On 2005 GSXR1000 when I install the jumper I get the C00 code. How do I get rid of the F1 and light if nothing is wrong?Looked through everything listed and I did not see anything about it.
After riding over 10,000 miles on my 2006 750, FI started to show instead of temperature… (only) sometimes. Took it to dealer who said it needed to adjust exhaust valve (the wires) – as the error was shown because the valve did not fully close. 8,000 more miles since then and no problem. ..