What does ECM mean on a Harley?
Electronic Control Module
Newer bikes display abbreviations to represent each module: ECM: Electronic Control Module. BCM: Body Control Module. SPDO: Speedometer.
What does the ECM do on a Harley Davidson touring?
The ECM is the computer on your Harley Davidson Touring that reads the sensors and tells the motor what to do. Resetting it allows it to start fresh and relearn any mods you have made. This article applies to the Harley Davidson Touring (2000-2015).
How do you reset the ECM on a Honda Accord?
Turn your starter switch to the “Run” or “On” position. Insert your key into the ignition and turn it on as well as off four times, relatively quickly, with a second or so pause in each position. Turn the key on, pause, off, pause, on, pause, off, pause, on, pause, off, pause, on, pause, off. Your ECM is now reset. Figure 3.
Why does my odometer go out on my Harley Davidson?
The problem randomly while riding the 6th gear indicator will go out, the speedometer drops to “0”, odometer stays on but stops recording mileage, no codes are displayed. Not aware of lights on or off haven’t rode at night when it happens.
What causes check engine light to go out on Harley Davidson?
It is roughly 25 miles to the dealership, about 3 miles from the shop it went out, this time the check engine light came on, 2 blocks from the shop I stopped at a traffic light when I pulled off everything resumed working. Mechanic plugged into ECM no trouble codes were recorded. He has no clue what could be causing this to happen.
The ECM is the computer on your Harley Davidson Touring that reads the sensors and tells the motor what to do. Resetting it allows it to start fresh and relearn any mods you have made. This article applies to the Harley Davidson Touring (2000-2015).
Turn your starter switch to the “Run” or “On” position. Insert your key into the ignition and turn it on as well as off four times, relatively quickly, with a second or so pause in each position. Turn the key on, pause, off, pause, on, pause, off, pause, on, pause, off, pause, on, pause, off. Your ECM is now reset. Figure 3.
Why does my Harley Davidson go into limp mode?
As soon as possible afterwards though, you should get your bike checked over to find the reason why it went into limp mode in the first place. One of the more common reasons for limp mode are corroded or lose pins on the ECM itself, exasperated by rough or bumpy roads.
Why does my ECM go into limp mode?
One of the more common reasons for limp mode are corroded or lose pins on the ECM itself, exasperated by rough or bumpy roads. Many people also believe that any modification made to the bike requires an ECM reset; however, this should not be the case. After a few cycles of starting and stopping, the ECM should learn your new setup on its own.