What does an ignition switch actuator pin do?
The purpose of this part is not only to start the vehicle, but to prevent the key from coming out of the ignition when the vehicle isn’t in Park. Steering column actuators were designed to connect the contacts from the ignition to the starter relay.
How to replace Ignition actuator switch key pin?
Jeep Ignition Actuator Switch Key Pin Replacement – The right way! Dorman 924-704 – YouTube
How do you replace a steering column actuator?
Turn the key to the start position and use your straight dental pick to release the pin in the pin hole. Then gently remove the ignition tumbler from the steering column. Step 21: Take remove three plastic clips to take out the clock spring.
Can a bad ignition switch cause a broken steering column?
A bad ignition switch or broken steering column actuator will also generate heat due to overheating in the electrical current. If you notice that your key and ignition switch is warm to the touch, this is also a potentially dangerous situation that should be examined by a professional mechanic.
What causes the ignition switch to heat up?
4. Overheating ignition switch A bad ignition switch or broken steering column actuator will also generate heat due to overheating in the electrical current. If you notice that your key and ignition switch is warm to the touch, this is also a potentially dangerous situation that should be examined by a professional mechanic. 5.
Jeep Ignition Actuator Switch Key Pin Replacement – The right way! Dorman 924-704 – YouTube
When to replace ignition cylinder actuator rod?
Ignition Cylinder Actuator Rod Replacement (1997-2003 F150s) This is an article that generally applies to 1997-2003 F-150 trucks. It may also apply to other years and models of Ford vehicles. I have a 2003 F150 Lariat – I went to start it today and as I turned the key, I heard a snap. It was definitely something plastic that made the noise.
When to replace ignition cylinder actuator in F150?
Keywords: ford f150 f-150 key ignition accessory start run on in repair replace fix broken broke actuator rod plastic assembly steer steering column starter This procedure is from a 2001 F-150 with power door lock problems. This article shows you how to change your door lock actuator.
How do you replace an ignition cylinder rod?
It’s a plastic piece that connects to the lower actuator with a pin. Apparently the pin can come out, so it will no longer move the lower actuator. In short, the repair procedure is basically: Removed the airbag, steering wheel, turn signal assembly, ignition cylinder, tilt, and the housing. It took me about an hour to get through everything.