What does a 4 inch centerset faucet mean?
The four-inch measurement for a centerset faucet refers to the center to center distance between the two furthest mounting holes. Centerset faucets have three mounting holes. All faucets with this kind of mounting pattern are measured between the two furthest spaced openings to get the desired measurement.
How do you measure a centerset faucet?
Make sure to measure your faucet centers. This refers to the distance, in inches, between the pre-drilled faucet holes in the sink or vanity, from the very center of the left hole to the very center of the right hole. These center points should correspond to the center connections of the faucets to be installed there.
How do you tell if a faucet will fit?
Measure. If you have three holes in the sink or counter, you will need to measure the distance from the center of the hole on the left to the center of the hole on the right. If this measurement is 6 inches or larger, you can install a “widespread” or “8-inch spread” faucet.
How do you measure a faucet diameter?
How to Measure the Faucet Hole Size?
- Place the inside jaw of the caliper against the inside of the faucet hole.
- Slide the scale outward until it reaches the maximum distance.
- Slide the caliper out and the reading indicated would be the size of the faucet hole in diameter.
What is the difference between centerset and single-hole faucet?
Faucet Handles A faucet that requires a single-mounting hole does not mean that the faucet must have only one lever to control the flow of hot and cold water. However, a 4-inch centerset faucet needs three mounting holes and cannot be used with a sink or countertop’s single-hole configuration.
What does widespread mean in faucets?
Widespread faucets feature separate hot and cold handles that are independent from the spout and can be mounted on the countertop or on sinks. It can be mounted on sinks with three holes that fit 8 inches to 16 inches from one side to the other. They are available in a wide range of styles and finishes.
What is the standard faucet size?
1 3/8 inches
A standard sink faucet hole has a diameter of 1 3/8 inches, but because not all faucets are the same, some will require a 1 1/2-inch hole. It’s also important to check the depth of the sink or countertop before installing a faucet or drilling a hole. If the deck is too thick the faucet may not fit correctly.
How many inches is the hole spread on a widespread bath faucet?
If the distance is six inches or more you need a “widespread” or “eight inch spread” faucet. If the measurement is less than six inches you need a “centerset,” “mini-spread” or a “four inch spread faucet.” Each of these configurations is for a faucet that will use all three holes in the sink.
What is the difference between widespread and centerset faucets?
The primary difference between widespread faucets and centerset faucets is in their design and installation. Widespread faucets come with separate handles. They are not connected and they are not mounted onto a base plate. Centerset faucets usually come as a single unit, with the faucet and handles connected.
How far should faucet hole be from sink?
The distance between the faucet body (where the water enters the faucet) and the areator is usually 8 to 10 inches for a kitchen faucet. However some oversized faucets have a reach of 11 to 16 inch.
Do centerset faucets need 3 holes?
A centerset faucet works with both single-hole and 3-hole basins; this is an easy-to-install option. This style features a deckplate that contains the handles and spout in one plate. This type of faucet can be used on sinks and countertops with one to three holes. Centerset faucets require holes with 4-inch centers.