What does 50s style wiring do?
With ’50s wiring, the tone cap is connected to the output, or center, lug on the volume pot. Advocates of ’50s-style wiring say that it changes the taper of the volume control, has less treble loss as the volume pot is turned down, and overall sounds brighter.
When did Gibson stop using 50s wiring?
The way original Les Paul models were wired, until they stopped making them around 1961, is what’s now known as “50’s wiring” and actually differs radically from modern Gibson wiring – but you wouldn’t think so to look at it.
What kind of wiring does Les Paul use?
In theory this might sound neat, but it does take out a huge amount of your high end. The Les Paul 50s wiring is what it’s actually all about. That particular schematic focusses on the tone pot/volume pot relationship. As with the volume pot, there are two ways of wiring up the tone pot.
How many pots does a Gibson Les Paul have?
A Gibson Les Paul, SG, ES-335 and many other guitars use a two-pickup/four-pot setup: two dedicated volume controls and two dedicated tone controls. The tonal possibilities are almost endless if you know how to dial it in right, and the tireless tinkerers among us have tried several ways of hooking up the pickups to the pots over the years.
What is the independent volume mod on Les Paul?
This wiring is called the ‘independent volume mod,’ because in the middle position you are now allowed to dial in the exact tone you want without sacrificing volume. In theory this might sound neat, but it does take out a huge amount of your high end. The Les Paul 50s wiring is what it’s actually all about.
What kind of capacitor does a Gibson Les Paul use?
Most of the older Gibson Les Pauls used a .047uf capacitor on each tone control. A more common modern value is the .022uf capacitor. You may want to experiment by going even lower to .01uf as some people feel it gives a broader tone control range. The output jack is a simple and inexpensive component that you can find in almost any music store.