What do you need to change a CV axle?
Tools and Equipment Needed to Replace a CV Axle
- Breaker bar.
- Dead-blow hammer.
- Drain pan.
- Jack and jack stands.
- Large hammer or mallet.
- Long-handled diagonal cutting pliers.
- Pry bar or CV axle puller.
- Ratchet and socket set.
Where can I find step by step axle removal instructions?
You can use the social sharing buttons to the left, or copy and paste the website link: https://www.diyford.com/ford-axle-removal-complete-step-step-instructions/ The most important aspect of safety is to be aware of your surroundings and take the time to remove any dangerous or hazardous items.
How do you replace a CV axle in a rear drive vehicle?
Step 1: This is a rear drive vehicle with two CV joint axles. Start by disconnecting the battery, jacking up the vehicle and allowing some penetrating oil to soak into any retaining bolts.
How do you take an axle out of a transmission?
If the car does not have this bearing use a large pry bar and wedge it between the transmission case and the axle and pry outward. This will pop the axle out from the transmission and enable you to remove the axle. Grasp the axle firmly while holding the spindle outward and pull the axle out from the transmission.
What to do before cutting a Ford axle?
Remove all jewelry and tie back long hair before performing any service work. If any cutting torches or welding work is required, use the correct eye shields and remove any solvents or dirty rags that may be in the area. Always have a fi re extinguisher that is up to date and nearby, just in case.
What’s the best way to change an axle?
By this time, you can put the wheel back on the vehicle (again, the same as you would when changing a tire). After the wheel is on, you can lower the car off the jack and jack stands. Tighten the axle nut. Finally, you can retighten the axle nut once the vehicle is back on the ground.
Step 1: This is a rear drive vehicle with two CV joint axles. Start by disconnecting the battery, jacking up the vehicle and allowing some penetrating oil to soak into any retaining bolts.
What should I do if my axle is stuck?
This step should be fairly easy, if the axle seems stuck use WD40 on the spline and let it sit for the few minutes before continuing. This will loosen any rust that is present in the spine area. Don’t worry about damaging the snout threads because the axle will be replaced anyway.
Can a rear axle be removed from a car?
You have a couple of options when servicing the rear axle. You can do all the work with the axle installed in the car or remove the axle from the car and perform the work on an axle fixture. Each method has advantages and disadvantages. Are you working on a vehicle hoist or using a floor jack and jack stands?