What do automatic transmissions have instead of a flywheel?
Automatic transmissions eliminate the clutch and grinding. Basically automating the shifting process so the driver does not have to worry about shifting gears while driving. A flexplate is mounted to the crankshaft and connects the output from the engine to the input of a torque converter.
Is there a flywheel in an automatic transmission?
Basically a flywheel or flex plate is the round metal disc shaped component that transfers power from the engine to the transmission. A flywheel is usually referenced to a car with a standard transmission,and a “flex plate” is used with automatic transmissions. The ring gear on a flex plate and a flywheel can fail.
How expensive is it to replace a flywheel?
When you add it all up, the average car owner is going to have to pay somewhere between $500 and $1,000 in most cases for flywheel replacement. That makes it one of the most expensive parts to replace in your powertrain.
How do you replace the flywheel on an automatic transmission?
How to Replace the Flywheel on an Automatic Transmission. Park the vehicle on a level floor. Jack up the front, then the back, of the car to place one jack stand under four supporting frame points to carry the vehicle at least 24 inches off the ground to replace the flywheel on an automatic transmission.
How do you remove a flywheel from a truck?
Lower the jack just slightly and pull the transmission back enough to gain access to the flywheel. Lift the jack enough to pin the transmission to the floor of the truck so it won’t fall. Remove the flywheel by removing the center bolts. When the flywheel comes off, be careful as it is heavy.
How do you remove transmission from cross member?
With the weight of the transmission resting on the jack, remove the transmission mount bolts. Removing the transmission mount bolts (or nuts) allows the transmission to be separated from the cross member. Remove the cross member to frame mounting bolts and then remove the cross member.
How do you remove a transmission fill tube?
Pull the transmission bell housing bolts after removing the one that secures the transmission fill tube in place. Normally this bolt is located at 1 o’clock and has the fill tube bracket held in place. Remove this bolt entirely and pull the transmission fill tube out from the transmission from within the engine compartment.