What causes vibration in a Mitsubishi Pajero nm?
Cheers John thanks for your ideas! just finished engine rebuild on 6g74.. added extractors and torque cam . cant find cause of engine vibration 2,100 to 2,600 rpm. harmonic balancer is good , compression is even, injectors and coils ext good, new after market engine mounts, any ideas.
Are there any problems with the Mitsubishi Pajero?
ZA, West. Cape, Hermanus starttimoottori ? 4M40 Diesel fuel system. uphill powerloss. Relays cut in/out – ign turns off/on when engine warm (after 5kms) when speed drops below 60ks. cold start problem.First one of the day is very bad.After that aok.
What to do with a Mitsubishi Pajero NP?
A common glitch in mine too. Just check your fluids and keep working your 4wd low ranges regularly. Make sure you disengage correctly by stopping, then move the shifter out from whatever low range gear you’re, in back one at a time, then drive forward slowly, not under load until light blinks out. Then you can drive off in normal gearing.
What to do if your Pajero has no spark?
I really have no definitive answer. It could be anything. I would take No1 plug out reattached lead, ground plug and see if there is spark. If not it could be the coil, engine immobiliser, no fuel or a fault in the ECU. Check the Pajero Club Victoria web site. There is a good forum there Cheers John thanks for your ideas!
What kind of fuel injection system does Pajero V6 have?
Note that if you get all the codes being sent to your meter, check for an open ground/power circuit. For an excellent in-depth discussion on the workings of the Fuel-Injection System in the 3.0l V6, refer to John Parkinson’s three- part series for the Mitsubishi 4WD Owner’s Club of Queensland: Pajero V6 Fuel-Injection Systems.
What should the idle speed be on a Mitsubishi?
Idle speed should be 750 rpm once warmed up independent of load placed on the engine. Locate that stepper motor, pull it out, and measure resistance across each coil. One will be open circuit. Go take some off Magnas at the wreckers. It’s a common problem with the Magnas as they age. No OBD2 error shown.
When to troubleshoot a Mitsubishi 3.0L V6 engine?
The information in this article is specific to the 1989 3.0l V6 motor. Many aspects of this procedure are common to all 3.0s, but it is advisable to consult a service manual before you troubleshoot your own engine.
Why is my Mitsubishi Lancer cutting out at low revs?
Yep I had the same issue many years back with an old Lancer, it would “stall” after starting unless I kept up the revs, turns out the idle speed motor is what handles these revs. Swapped it out and all good.