What causes high injector flow at 1200 rpm?
Check for a high injector return flow. Measure the flow at the injector return line connection at the rear of the cylinder head. Maximum allowable values are 90 mL at cranking and 160 mL at 1200 RPM with 1400 bar rail pressure. High return is commonly caused by loose connector tube retaining nuts.
What does a p0122 code on a throttle position sensor mean?
A P0122 code means that the the vehicle’s computer has detected that the TPS (throttle position sensor) “A” is reporting too low a voltage. On some vehicles that lower limit is 0.17 – 0.20 volts (V). In simple terms, the throttle position sensor is used to determine what position the throttle is at. Did you adjust it…
What are the symptoms of a bad throttle / accelerator pedal?
Symptoms of a Bad or Failing Throttle/Accelerator Pedal Position Sensor. $79.99 – $89.99. Average rating from 4,829 customers who received a Check Engine Light is on Inspection. The days of having to constantly adjust the throttle cable due to a loose nut on the carburetor are long gone.
When to call a mechanic for bad throttle control?
This could cause a serious safety hazard, as the driver is not able control the speed or acceleration of the vehicle. When this occurs, you should pull your vehicle to a safe place off the road and contact a mechanic as soon as possible to inspect why throttle control is not consistent. 2. Engine does not run efficiently
What causes a car to idle at 1500 rpm?
The idle control circuit is very common to have problems. Pull the ecu and check the board for damage. Vacuum leaks, TPS settings, BISS settings, throttle cable adjustment, stop screw adjustment. All of these have cause idle issues on my car at one point or another.
How to perform Ford idle relearn you MPT performance?
Turn the air conditioning on and allow the engine to idle for at least one minute. Release the parking brake. With your foot on the brake pedal and the A/C still on, put the vehicle in “D” (Drive) and allow the engine to idle for at least one minute. Drive the vehicle to complete the relearning process.
What does it mean when your engine idle is too low?
If your idle is too low, it could be the IAC not talking to the computer correctly. Disconnect the IAC connector for a couple seconds while your engine is idling. If your engine idle didn’t change, you can suspect it to be the IAC. If it is working properly, unplugging it would cause your idle to freak out.
What happens when the idle control motor is disconnected?
With the Idle Control Motor disconnected, get back into the vehicle and start the engine again. The engine should still start and run without any issue despite the idle control motor being disconnected. Be sure to tuck the wiring you disconnected up in the engine bay so it doesn’t get caught in any moving parts.