What causes hard start on Ford Ranger?
The most common causes that hinders normal starting operation of your Ranger are dead key fob battery, dead 12v battery, corrosion on battery terminals, bad alternator, clogged fuel filter, broken starter, blown fuse, empty gas tank, immobilizer error or any fault in the electrical system.
How do you reset the inertia switch on a Ford Ranger?
Look on a side panel for a small, round button which you can pry off with a small screwdriver. Through this access hole you will be able to see the reset button on top of the inertia switch.
How do I get my Ford Ranger out of theft mode?
Resetting Your Anti-Theft System
- Put the key in the ignition.
- Turn it to the on position, but don’t start the engine.
- Turn it back off again.
- Repeat this process eight times, leaving your key on with the final turn.
How do I manually start my Ford Ranger?
How it works
- As long as your key fob is with you, in your bag or pocket, the system senses when it’s within range of your car.
- Just pull on the front door handles and they’ll unlock.
- Once inside, put your foot on the brake, press the START/POWER button and drive away.
How long do Ford Rangers usually last?
Trucks aren’t made to last forever. But, most pickup trucks are made to last for a fair amount of time. Fortunately, the new Ford Ranger is one of those trucks. Because, according to Motor and Wheels, you can count on the Ranger to last up to 300,000-miles.
Where is the inertia switch on a 2004 Ford Ranger?
You can find the inertia switch, which is also known as the fuel pressure inertia switch (FPIS), on Your Ford Ranger’s passenger foot area, under the dash, near the front edge of the carpet.
Why does my Ford Ranger engine shut off without warning?
Engine stalls and won’t re-start due to improper activation of the passive anti-theft system (pats) which is faulty. Engine shuts off, no power assist, lights remain functional, anit-theft dashboard light starts to blink.
What was the problem with my 2005 Ford Ranger?
I am the owner of a 2005 Ford Ranger there was a problem with the transmission. It was taken to the dealer after approximately 5 days we were able to pick the Ford up and the transmission was replaced. Shortly after this the vehicle started to shut down while driving for no apparent reason .
What’s the problem with the clutch on a Ford Ranger?
Issue: You have to push the clutch to the floor to shift gears. Problem: More times than not, you still have air in the clutch line and need to further bleed the system. Fix: If a new installation: check pedal height and adjust to factory specifications.
What causes brake booster failure in a Ford Ranger?
Because the Ford Ranger uses a vacuum brake booster, failure usually has to do with some sort of pressure leak, but it can also be due to a mechanical failure in the booster itself.
https://www.youtube.com/watch?v=-QnCwG-_kSc