What causes a Pontiac Montana transmission to flush?
A flush can circulate metal and dirt particles into the fluid and cause major problems in the transmission. 2005 was the final year the Pontiac Montana was produced. Park the Pontiac Montana on a level surface so all the fluid can properly drain. Pop the hood and remove the dipstick located near the rear of the engine.
How do you change transmission fluid in a minivan?
Slide under the minivan with a socket wrench and an oil drip pan. If you need more room under the van, use a jack to raise the van 6 inches. Unscrew the drain plug lug on the transmission fluid pan.
How much does it cost to replace a Pontiac Montana transmission?
About Automobile indicates that the average cost to replace a Pontiac Montana transmission is estimated at $2000-$2800 for parts and labor. To fix shifting problems, MSN Auto indicates that the Montana’s torque converter should be replaced. The estimated cost of a new torque converter is $350 for parts and labor.
What causes a transmission seal to blow or fail?
If the gasket fails, transmission fluid can be released, causing the fluid level within the transmission to fall, possibly causing costly damage. Transmission seals can blow, or fail, for a variety of reasons. If a gasket has aged, and has not been serviced consistently, it can crack or break completely in certain areas, allowing fluid to escape.
A flush can circulate metal and dirt particles into the fluid and cause major problems in the transmission. 2005 was the final year the Pontiac Montana was produced. Park the Pontiac Montana on a level surface so all the fluid can properly drain. Pop the hood and remove the dipstick located near the rear of the engine.
What was the Pontiac Montana mini van problem?
I have used less energy in a weight session, it was so bad. We own a 2001 Pontiac Montana mini van. We took the van in to have a/c checked as it was only blowing out warm air. The dealership said it was a condenser problem and would cost about $800 to fix. My parents also have the same year montana and their condenser also went in their van.
Slide under the minivan with a socket wrench and an oil drip pan. If you need more room under the van, use a jack to raise the van 6 inches. Unscrew the drain plug lug on the transmission fluid pan.
Why does my 2000 Montana overheat all the time?
We have a 2000 Montana and have the same thing with the temp gauge. It usually is caused by a slow leaking lower intake manifold. Common in GM 3.1 and 3.4 V6’s Just keep a check on the coolant level. My husband and I have the same problem but ours eventually overheated on the interstate one evening.