What causes a Mercedes flex disc to wear out?
Mercedes Flex Disk Causes 1 Car age. The older the car gets, the more degradation happens. 2 Heat and other elements. Since a flex disc is made of rubber, heat and other harmful elements slowly wear it out. 3 Alignment of drivetrain. When a drivetrain is misaligned, it will cause too much stretch on the flex disc causing the… More …
What kind of coupling device is Mercedes flex disc?
A flex disc or a giubo is a coupling device made of hard rubber. Input and output shaft flanges are bolted to the Mercedes Flex Disk on either side (see picture below).
How much does a Mercedes flex disk cost?
If you do it yourself you can spend around $100 for the Mercedes-Benz Genuine flex disk. If you would like to save even more there are many aftermarket flex disks for Mercedes-Benz for well under $100 USD.
Where are the Flex disks on a car?
Get under your car and inspect the rubber drive line flex disks located at both the front and rear of the drive line. Remember, these rubber parts are getting old. If you find the rubber is cracked then replace one or both. Don’t take the chance. They are not that expensive and will last another 15 – 20 years!
How does the flex disc work on a Mercedes?
A flex disc, also known as a giubo, is a coupling device made from hard rubber. Input and output shafts flanges are mounted on to the Mercedes flex disk on both sides. The transmission shaft, differential, and drive shaft are not directly interconnected. Rather, they connect via a flex disk. Functions of the Flex Disc.
How much does it cost to replace Mercedes flex disc?
Mercedes Flex Disc Replacement Cost. If you have an auto repair shop replace the flex disk on your Mercedes-Benz expect to pay between $300-$500 depending on your location and model of MB. If you do it yourself you can spend around $100 for the Mercedes-Benz Genuine flex disk.
Can a worn out flex disc cause damage?
Flex disc replacement is quite easy and inexpensive. Ignoring a worn out and damaged disc, on the other hand, can cause more costly and catastrophic havoc to your vehicle. It can damage your car’s transmission, driveshaft, and body.
What are the signs of a flex disc failure?
Common Signs of Flex Disc Failure 1 A “rough shift” feeling when shifting the car to drive or putting it in reverse 2 Excessive driveshaft movement due to an abnormal vibration at the center of the vehicle’s floor 3 A knocking-like noise from beneath the vehicle, which gets louder as the car accelerates More
Where do you put the axle shaft in a Mercedes Benz?
Fit the axle shaft into its mount either in the transfer case on the right side or the intermediate shaft on the left side. Position the outer CV joint of the axle shaft in the spindle being careful to line up the outer CV joint splines with the splines in the hub of the spindle.
What makes a Mercedes Benz front end Shimmy?
These forces can be extreme and cause the rubber bushings to fatigue and crack causing a front-end vibration or shimmy. Signs of failure are common and are often accompanied with a “creaking” noise from the suspension. Other components such as wheel bearings, ball joints and sway bar links should be inspected at the same time.