What are the trouble codes for Arctic Cat?
Arctic Cat Trouble Codes C0063-Tilt Sensor Circuit High C0064-Tilt Sensor Circuit Low P0107-MAP sensor Circuit Low P0108-Map Sensor Circuit High P0112-IAT Sensor Circuit Low P0113-IAT Sensor Circuit High P0114-IAT Sensor Circuit Intermittent P0116-ECT Sensor Circuit Range/Performance P0117-ECT Sensor Circuit Low P0118-ECT Sensor Circuit High
Why do I get an error code on my Arctic spa?
A Temperature Probe Error may occur when the temperature probe is disconnected from the base board. If the temperature probe is disconnected, the spa pack has no feedback to control the heater and temperature. As a result, the heater is prevented from running to avoid the water temperature from reaching unsafe levels.
How to contact Arctic Cat for customer service?
They are fully qualified to meet your needs. If after that, you’re still experiencing an issue, contact us at 218-681-9851 (USA) or 204-982-1656 (CAN) or fill out the form below and Arctic Cat Customer Service will contact you. Did you purchase this vehicle new or used?
What does p0562 mean on Arctic Cat Battery?
Gauge DTC display will clear when EPS-to-gauge CAN communication restored. P0562-System Voltage Low (Battery voltage low – seems to be a common problem with Arctic Cat Batteries. Put it on charger.) If your battery goes dead or you start getting error codes, check under the hood.
Arctic Cat Trouble Codes C0063-Tilt Sensor Circuit High C0064-Tilt Sensor Circuit Low P0107-MAP sensor Circuit Low P0108-Map Sensor Circuit High P0112-IAT Sensor Circuit Low P0113-IAT Sensor Circuit High P0114-IAT Sensor Circuit Intermittent P0116-ECT Sensor Circuit Range/Performance P0117-ECT Sensor Circuit Low P0118-ECT Sensor Circuit High
What happens if you dont enter the U1000 code?
After about 5 hours it will put the car into a limp mode I was told if not entered. Contact the dealer you purchased it through. yep, those codes were on mine at the dealer when purchasing and they had to clear them, just as albanate said.
How do you find the fault code on an Arctic Cat Prowler?
Locate the diagnostic plug and bend a paperclip into a U shape. Install the “jumper” into the BLK plug and the other end into the BLU/RED. Turn the key ON. This will display the fault codes as SC (stored code) or AC (active code) and then a number.
Gauge DTC display will clear when EPS-to-gauge CAN communication restored. P0562-System Voltage Low (Battery voltage low – seems to be a common problem with Arctic Cat Batteries. Put it on charger.) If your battery goes dead or you start getting error codes, check under the hood.