What are the torque specs for a Harley Davidson?
In addition to what has been said about torque specs. By using the lower number of range on lets say a 90-100 ftlbs. During a check of those bolts if it does not move then your good to go. If it does move, you can go to upper range of spec with out damaging any thing.
What kind of torque does a Jeep CJ have?
CJ-5/6/7 – Rod End (Connecting Rod) to Steering Knuckle Type: 50 600 CJ-5/6/7 – Rod Ends (Tie Rod) to Steering Knuckle Type: 12 144 Type: Bolt Transfer Case Assembly To Transmission 30 360 CJ-5/6/7 – Transfer Case to Transmission Bolts Type: Bolt
What are the torque specifications for a Chevy Corvette?
24.4 C4 – REAR Bushing Clamp Bolts Type: Bolt 65.08 C4 – Ball Joint to LOWER Control Arm Nut Type: 43.39 Type: 67.79 C4 – LOWER Ball Joint NOTE: 50 + Cotter Pin Align Type: 44.74 C4 – UPPER Ball Joint NOTE: 33 + Cotter Pin Align Type: 20.34 C4 – Master Cylinder Mounting Nuts Type: 32.54 Type: 32.54 Type: 21.69 C4 – REAR (Guide Pins) – LOWER Type:
How is torque spec related to gear Lash?
Its also not a torque spec, rather a tolerance spec related to/for gear lash, as the drive gear I’d mounted to the crank and runs the rear cam. In addition to what has been said about torque specs. By using the lower number of range on lets say a 90-100 ftlbs. During a check of those bolts if it does not move then your good to go.
In addition to what has been said about torque specs. By using the lower number of range on lets say a 90-100 ftlbs. During a check of those bolts if it does not move then your good to go. If it does move, you can go to upper range of spec with out damaging any thing.
How much torque does a cylinder head have?
Mark each head bolt and head with aligning marks. Tighten each bolt 1/4 turn (90 degrees). For each cylinder head, start with head bolt numbered one. In increasing number sequence (1-2-3-4), tighten the head bolt in four stages. 1. Tighten each bolt to 7-9 foot pounds of torque. 2. Tighten each bolt to 12-15 foot pounds of torque.
Its also not a torque spec, rather a tolerance spec related to/for gear lash, as the drive gear I’d mounted to the crank and runs the rear cam. In addition to what has been said about torque specs. By using the lower number of range on lets say a 90-100 ftlbs. During a check of those bolts if it does not move then your good to go.
Mark each head bolt and head with aligning marks. Tighten each bolt 1/4 turn (90 degrees). For each cylinder head, start with head bolt numbered one. In increasing number sequence (1-2-3-4), tighten the head bolt in four stages. 1. Tighten each bolt to 7-9 foot pounds of torque. 2. Tighten each bolt to 12-15 foot pounds of torque.
How many horsepower does a Shovelhead engine have?
From 1970 to 1984, maximum horsepower dipped slightly to 62, peaking at 5,400 rpm. Horsepower dipped to 60 in 1978 to 1980 models, climbing to 65 in 1981 through 1984 versions.