What are the most common 4L60E transmission problems?
No forward movement in OD or D, but L2, L1 and R work: Forward sprag is broken. Transmission must be removed and rebuilt. Try not to run or drive the car or further damage could result. 18. Extremely harsh shifts from P or N, normal shifts at WOT: EPC (Electronic Pressure Control) solenoid failed.
Why does my transmission have a hard shifting problem?
You would be surprised to know that the majority of the transmissions problems such as hard shifting and no shifting issues come from incorrect transmission fluid level or the infamous transmission 13 pin connector plug O-ring. These are easy fixes that you can even tackle yourself.
Can a Mercedes-Benz have a transmission failure?
Very few Mercedes-Benz cars have had complete transmission failure and require transmission replacement. We see these transmission fail in rare cases when water enters the transmission via the oil cooling lines or the radiator on cars equipped with Valeo radiators.
How to reset transmission adaptive shifting in Mercedes Benz?
If you race your Mercedes-Benz, it will remember that and keep the gearbox in gear longer. If you drive it gently, it will adapt to that as well and change gears earlier. Turn the key to position 2. You should see all the dash lights come on. Do NOT start the car.
No forward movement in OD or D, but L2, L1 and R work: Forward sprag is broken. Transmission must be removed and rebuilt. Try not to run or drive the car or further damage could result. 18. Extremely harsh shifts from P or N, normal shifts at WOT: EPC (Electronic Pressure Control) solenoid failed.
Why is my transmission not shifting to higher gears?
Other possibilities could be an engine related problem that will cause the computer to not allow the transmission to shift into higher gears. This condition can also be caused by low transmission fluid, contamination due to lack of maintenance or water intrusion, or internal wear and tear on the transmission parts inside the transmission.
When do you know you have a transmission problem?
You may be experiencing a problem with your transmission if your vehicle is exhibiting any of the following symptoms below:
What happens when you reset the transmission shift points?
It is not going to make your shifting abnormal. If your gear shifts are abnormal you have something else going on. Resetting the transmission shift points makes the transmission the same as when the car is out of the factory. Within 30 driving cycles, the ECU will monitor your driving habits and adapt the shifting points to your driving style.
Why is my Shift Solenoid not working properly?
Diagnosis is key when it comes to transmission problems, as various issues can cause similar problems. Trouble with wiring or sensors could be at fault instead. A faulty shift solenoid should be replaced. In some cases, the solenoid is integrated into the valve body and isn’t serviceable.
Why does my 4L60E have no reverse?
Slow, slipping or no reverse: “lo-reverse” clutches are worn out, fluid leak in the reverse apply circuit, or broken sunshell.
What to do when 2.1-2 shift does not happen?
2. 1-2 shift does not happen at WOT (Wide Open Throttle) until you let off the gas: Best case: try replacing the TPS. Middle case: leak in the 2nd gear apply circuit (servo assembly or 1-2 accumulator). Double check by using the pressure gauge and watch for a big drop when the PCM commands 2nd gear.
Can a GM 4L60 / E clutch pack get burnt?
Burnt 3-4 clutch packs are notoriously common in the GM 4L60/E family of transmissions. Tech hotlines and internet bulletin boards are often jammed-up with people pleading for help with this 3-4 roasting. Some technicians get frustrated and throw multiple Hail Mary replacement parts at the transmission when facing this issue.
What causes a WoT Shudder on a 4L60E?
3. 1-2 Shift shudder at WOT (Wide Open Throttle); delayed or abnormal 1-2 shift; There’s a problem ONLY on the 1-2 shift: 1-2 accumulator piston cracked or stuck cocked in the bore. Check the yellow spring inside the accum housing for breakage.
How much fluid does a GM 4L60E need?
The 4L60E transmission weighs 146 pounds dry, and 162 wet. It requires 8.4 quarts (9.64″ torque converter) or 11.4 quarts (11.81″ torque converter) of transmission fluid, Below is a list of common transmission problems with the GM 4L60E Transmission and possible solutions to repair.