What are the locking pins on a Renault dCi engine?
The K9K series of 1.5dCi engines require Crankshaft Locking Pin VS1220/02 and Pin VS125/R1 to position the camshaft/sprocket. As it is necessary to remove the right hand engine mounting/bracket when removing and installing the timing belt, the engine must be supported from below.
How to check torque of Renault dCi engine?
Using a torque wrench apply a clockwise(pre-tensioning) torque of 11Nm and remove tool. Fit a suitable belt tension gauge to belt and screw in the VS4760.T6 Bolt until specified reading is obtained. Rotate the crankshaft two turns and return to TDC. (Check position by inserting VS125/R1 Pin but DO NOT leave Pin in crankshaft).
How do you check the timing on a camshaft?
Position the camshaft sprocket timing mark just before the mark on the rear cover. Remove crank pin blanking plug from cylinder block, insert VS125/R1 Crank Locking Pin and rotate crank slowly in a clockwise direction until Pin enters crankshaft to determine TDC. Check camshaft timing marks align, remove VS125/R1 Pin and crankshaft pulley.
Where are the timing marks on a dCi engine?
Ensure that the marks on the belt are aligned with the timing marks on the camshaft, HP pump and crankshaft sprockets. There should be 19 tooth spacesbetween camshaft and HP pump timing marks and 51 tooth spacesbetween crankshaft and HP pump marks. Fig.2 4.2.2 VS4760.T6 and VS4759.V2 Tensioning Tools (Fig.5)
Where are the timing belt marks on a Renault?
According to the Haynes manual there should be a mark on the camshaft pulley which should coincide with a mark on its backing plate. On some engines there are marks on the flywheel which can be viewed via the TDC sensor aperature.
The K9K series of 1.5dCi engines require Crankshaft Locking Pin VS1220/02 and Pin VS125/R1 to position the camshaft/sprocket. As it is necessary to remove the right hand engine mounting/bracket when removing and installing the timing belt, the engine must be supported from below.
How to timing a Renault 1.6L engine?
Preparation and precautions: Fig. 1 • Raise the front of the vehicle and remove the front wheels and inner wheel arches as required. • Remove the engine under shield, top cover, air intake, auxiliary drive belt(s). • Ensure the engine is at TDC cylinder number 1.
How is the timing belt tension set on a Trafic?
With this engine the timing belt tension is set using a pre tensioning tool and a tension gauge, both are special tools from Renault, not available to public and other versions are very expensive.