What are the features of a crane Hi 4e?
The HI-4E features: • Switch selectable multi-spark mode.Crane’s exclusive FIRE(Fast Inductive Restrike) generates up to nine sparks at idle and three sparks up to 6,000 RPM. Reduces lean surge and plug fouling. • Switch selectable single or dual fire.Initially the unit can be installed using the OE dual fire coil.
What do I need to install a hi 4e?
1. These models did not have a plug at the ignition mod- ule. To install the HI-4E model 8-3100, you will require H-D® ignition module adapter wiring harness kit P/N 32408-90. This part is not included with the HI-4E and can be purchased from your local dealer. Follow the supplied instructions to upgrade your wire harness for plug-in ignition.
How do you install a Hi 4 ignition?
Install the HI-4 first, then push the cable through the hole. Align the V notch on the HI-4 same as the O.E. plate you removed. Use the O.E. standoffs to secure the HI-4.You must use lock washers under the standoffs for proper clearance between the HI-4 and cover plate. Do not fully tight- en the standoffs until the timing has been set. Figure 3.
How tall is an Elliott hireach h70r Crane?
ELLIOTT H70R Standard features: One new Elliott HiReach H70R, having a 70’ working height. Basic unit includes base assembly supporting rear mounted rotating turret, hydraulically powered continuous rotation mechanism, oil reservoir mounted to truck frame, oil, and manual hydraulic controls mounted to turret.
The HI-4E features: • Switch selectable multi-spark mode.Crane’s exclusive FIRE(Fast Inductive Restrike) generates up to nine sparks at idle and three sparks up to 6,000 RPM. Reduces lean surge and plug fouling. • Switch selectable single or dual fire.Initially the unit can be installed using the OE dual fire coil.
How do you install a Hi 4 on a motorcycle?
Rotate the HI-4 about 90 degrees to give better access to the cable exit hole in the gear case cover. On some early models and Sportsters, it will be necessary to enlarge this hole. Install the HI-4 first, then push the cable through the hole. Align the V notch on the HI-4 same as the OE plate you removed.
What kind of coil do you need for a hi-4 ignition?
We recommend replacing the O.E. coil. Coils used with the HI-4 must have at least 2 ohms primary resistance. Coils with 4 ohms or higher may be used, but may not produce optimum output. We rec- ommend the following coils for single and dual-plug applications: HI-4 Ignition With Single Plug Heads.
What kind of breaker do I need for a hi-4?
For models prior to 1980, use the supplied 10-32 x 3/4″ bolt and washer to mount the rotor. 1. Install HI-4 system in place of OE breaker or sen- sor plate. Rotate the HI-4 about 90 degrees to give better access to the cable exit hole in the gear case cover.