What are the error codes on a 2002 Camry?
2002 Camry 2.4 2AZ-FE. Pulled the engine for a rebuild. Now I have error codes P1300, P1305, P1310, P1315. Car is hard to start and sounds like a lawn mower.
How does a Toyota DIS ignition system work?
This is from Toyota (bold and some parenthesis added by me): The DIS (Distributorless Ignition System) is a 1-cylinder ignition system in which each cylinder is ignited by one ignition coil and one spark plug is connected to the end of each secondary wiring.
How does the ECM work on an igniter?
The ECM determines the ignition timing and transmits the ignition (IGT) signals to each cylinder. Using the IGT (coil fire) signal, the ECM turns the power transistor inside the igniter on and off. The power transistor, in turn, switches on and off the current to the primary coil.
How to check for code on all 4 ignition coils?
For a code on all 4 ignition coils, your checks will go as follows: 1. Ground check. Check resistance between pin 4 (ground) of the ignition 3 coil connector and a good ground. You should have less a than 1 ohm reading.
How much does it cost to diagnose p1310 Toyota code?
The cost of diagnosing the P1310 TOYOTA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour. When is the P1310 TOYOTA code detected?
What does the OBD 2 fault code p1310 mean?
OBD II fault code P1310 is a manufacturer specific code that is defined by carmaker Toyota, and Lexus in particular, as “Igniter Circuit Malfunction No.3.” This code refers to a malfunction in the ignition system, with the malfunction being the lack of an IGF (Ignition Feedback) signal between the igniter…
How to check OBD 2 diagnostics on a Toyota Camry?
It is important to connect the car computer engine when the OBD 2 software is ready to be able to make the OBD 2 check up software to identify the required plug in, the user needs to run the needed software on the Toyota Camry car computer. Follow this process; It is with this that will make the use of this OBD 2 a straight forward affair.
How much does it cost to diagnose P1300 Toyota code?
The cost of diagnosing the P1300 TOYOTA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour. When is the P1300 TOYOTA code detected?
What does OBD II fault code P1300 mean?
What Does Code P1300 Mean? OBD II fault code P1300 is a manufacturer specific code that is defined by carmaker Toyota, and Lexus in particular, as “Igniter Circuit Malfunction No.1”, or sometimes as “Igniter Circuit Malfunction (Bank 1), in cases where each bank of cylinders is fitted with a separate igniter.
What are the common causes of P1300 malfunctions?
Common causes of P1300 could include the following- Damaged, burnt, shorted, disconnected, and/or corroded wiring and connectors Defective ignition coils Defective igniter Defective PCM