What are the different parts of a condenser?
A cabin which is a housing for other parts, coils which can be made by copper or aluminum, a compressor which is for increasing pressure and a fan whose job is flowing air into coils. The coils can be made of copper or aluminum and it’s better to be of aluminum so heat can be better and faster transferred.
How do you replace a condenser in a Ford?
Insert the condenser’s single screw through the top of the condenser and into the distributor, then tighten the screw with a standard screwdriver. Slide the condenser’s wire onto the threaded rod on the side of the breaker points assembly, then tighten the nut over the tip of the wire with a wrench to firmly secure the wire to the points assembly.
How do you remove a condenser from a distributor?
Loosen the nut with an open-end wrench and pull the wire off of the threaded stud. At the other side of the condenser is a standard screw, which secures the condenser to the distributor. Remove this screw with a standard screwdriver, then lift the condenser out of the distributor. Remove the breaker points.
Where is the condenser located on a Ford distributor?
The plastic rotor slides onto the top of the metal shaft located in the center of the distributor, sometimes called the “cam.” Pull the rotor off of the cam. Remove the condenser. The condenser is the metal cylinder which has one wire protruding from its side.
How to replace a capacitor in a HVAC condenser?
Slide in the new capacitor into the metal strap, push on the two wire terminals with the needle nose pliers, replace the fuse block/handle in the outside power supply box, turn on the A/C breakers inside the house, and turn on the A/C system at the thermostat. I had also turned off the breaker switch on the air handler, so I turned that on as well.
What do you need to replace a condenser on a car?
These may include the car’s radiator, radiator and condenser fans, grills, headlights, mounting brackets, lock brace, supports and in some cases the bumper. Do not release the condenser from its mounts yet, just remove parts that are in the way.
How long does it take to replace an AC condenser?
Before any new refrigerant can be added the AC system must be placed into a vacuum. This can be done using a recovery machine or using a manifold gauge set and a vacuum pump. The high and low side lines must be hooked up to the vacuum pump. The system is placed in vacuum for at least 30 minutes, preferably longer.
Do you have to replace the O-rings on an AC condenser?
The next step will be to replace the o-rings on the AC lines going to the condenser. Note: These o-rings can only be used one time and must be replaced or your system will leak. Coat the the o-rings with the system oil to ensure a good seal. Once the o-rings are replaced the lines can be bolted back to the condenser.