What are the codes on a Harley Davidson?
Turn IGN OFF to exit diagnostic mode. If IGN is not turned off, vehicle will exit diagnostics mode when vehicle starts moving. There are three types of DTCs: current, pending and historic. The odometer self-diagnostics displays all codes and differentiates between current and historic with a letter designator.
What is code used to support P & A parts?
Code used to support P&A parts. BCM not configured properly. BCM not configured properly. BCM not configured properly. This DTC should only apply to CVO models. BCM not configured properly. This DTC should only apply to CVO models. BCM not configured properly. This DTC should only apply to CVO models.
When does the error free cycle clear the DTC?
On the 40th error free cycle, the DTC will clear itself. It is important to note that historic DTCs will exist whenever the system indicates existence of a current fault. See Multiple Trouble Codes. if multiple DTCs are found.
What does the p2314 code on a car mean?
What the P2314 code means. P2314 is a generic OBDII code that signals a problem with secondary ignition on the 5th cylinder.
What does DTC p2314 stand for in PCM?
DTC P2314 indicates that the powertrain control module (PCM) has detected a fault on the secondary ignition coil circuit. The code sets when the secondary ignition burn time is too short, incorrectly timed, or not present.
How to get the trouble codes on a Harley Davidson?
The following procedure will instruct in retrieving and clearing ECM Diagnostic Trouble Codes and TSM/TSSM codes through the Harley gauge cluster as well as a list of codes. 1- Turn Ignition switch to OFF & Run/Stop switch is to Run. 2- Push odometer reset button in & hold.
Are there any problems with my Harley Davidson?
BCM not configured properly. BCM not configured properly. BCM not configured properly. This DTC should only apply to CVO models. BCM not configured properly. This DTC should only apply to CVO models. BCM not configured properly. This DTC should only apply to CVO models. BCM not configured properly. This DTC should only apply to CVO models.
Where is the diagnostic switch on a Harley Davidson?
To enter diagnostic mode, press and hold the trip odometer trigger switch located on the left handlebar controls, while turning the IGN ON. The trip odometer trigger switch is located in the left hand control module.
Where is the ECM code on a Harley Davidson?
1. Release the trip odometer trigger switch. “diag” will appear on odometer display. 2. Press and release trip odometer trigger switch. ECM will appear on odometer display. It will have either a “Y” or an “N” after it, depending if there are any ECM codes or not.
BCM not configured properly. BCM not configured properly. BCM not configured properly. This DTC should only apply to CVO models. BCM not configured properly. This DTC should only apply to CVO models. BCM not configured properly. This DTC should only apply to CVO models. BCM not configured properly. This DTC should only apply to CVO models.
Where is the Diag switch on a Harley Davidson?
The trip odometer trigger switch is located in the left hand control module. The switch signal is sent to the speedometer over the CAN bus. If there is a problem with the CAN bus, the odometer self-diagnostic mode may not function. 1. Release the trip odometer trigger switch. “diag” will appear on odometer display.
1. Release the trip odometer trigger switch. “diag” will appear on odometer display. 2. Press and release trip odometer trigger switch. ECM will appear on odometer display. It will have either a “Y” or an “N” after it, depending if there are any ECM codes or not.